Hans Grohe 15180XX1, 15181XX1 User Manual

Installation Instructions / Warranty

Electronic

15180XX1

Electronic

15181XX1

2

Hansgrohe Electronic Lavatory Faucet with Temperature Control

16

15180XX1
Hansgrohe Electronic Lavatory Faucet
15181XX1

Technical data

Max. water pressure: 116 psi
Recommended pressure: 14.5 - 72 psi
Hot water temperature: max. 158 °F*
Recommended hot water temperature:
Rate of flow:
Automatic shutoff: after 35 seconds
Hole size in mounting surface: 1 3/8“
Max. mounting surface thickness 1 1/8“
Requires standard 110V electrical outlet.**

*please know and follow all applicable local plumbing codes when
setting the temperature on the water heater. In Massachusetts, the
water heater may be set no higher than 112

**please know and follow all applicable local codes regarding
placement and type of outlet.

120°F - 140°F*

1.5 gpm @ 44 psi

o

F.

Caution: do not bend or twist the supply
hoses!

Installation

Flush the hot and cold supplies thoroughly before
installing this faucet.

Place the faucet in the hole in the mounting surface
(1).

From beneath the sink, install the fiber washer, metal
washer and mounting nut (2).

Install the adapters on the stops (3).

Install the filters (4) and supply lines (5).

Connect the transformer. Plug into the outlet.

Use a cable tie to bundle excess cable.

3

4

Turn the water on to the faucet (1).

Peel the protective film from the sensor (2).

Wait 15 seconds, then put a hand in front of the sensor.
The water should turn on automatically.

Model 15180 only: Pivot the temperature control
lever forward to make the water cooler.

Model 15181 only: Turn the water off at the stops (1).

Remove the set screw on the back of the faucet (2).