Installation Instructions / Warranty
3-Jet Wallbar Set 06888XX0
Wallbar 06890XX0
90965601 05/2002
Installer Notes
These installation instructions show that water will be furnished through an existing
shower arm. This is not the only installation possible. A Hansgrohe 27454XX1 or
equivalent wall supply may also be used.
The screws and anchors included with this set are suitable for use in a tile or other
solid-surface wall. They are not suitable for use in an acrylic or fiberglass shower
enclosure. Please contact the manufacturer of the enclosure regarding recommended mounting locations, reinforcement requirements, and recommended
mounting hardware.
Backflow Prevention
A backflow preventer (or vacuum breaker) is required by many local plumbing
codes to protect your drinking water from back siphonage.
Hansgrohe recommends the use of external vacuum breaker 06510000 if
backflow prevention is not provided by another device, such as a 27458XX1 wall
outlet with integral vacuum breaker.
Remove the old showerhead
• While holding the shower arm, remove the existing
showerhead by turning counter-clockwise with an
adjustable wrench.
• Thoroughly clean the threads on the shower arm with a
wire brush.
2
Install the Wallbar
Tools Required (not included): a) adjustable wrench, b) drill with 1/4" (6.4 mm) bit
suitable for the wall surface, c) Philips head screwdriver, d) silicon sealant, e)
plumbers thread tape (i.e. Teflon
• Remove decorative screw covers from wall bar end
pieces. Position bar so hand shower may be adjusted at
a convenient height for intended users. Mark location of
mounting holes. Put wall bar in a safe location. CAU-
TION: Do not install wall bar directly between shower
arm and valve. A water line may be located there and
may be damaged while drilling mounting holes.
• Drill holes through shower wall.
Install anchors. Seal wall around the
anchors with silicon sealant.
TM
tape)
• Attach wall bar to wall using screws and metal washers
provided.
• Reinstall decorative screw covers.
3