Hans Grohe 06571XX0, 06631XX0, 06575XX0 User Manual
Installation Instructions / Warranty
Solaris E
06631XX0
Stratos E
06575XX0
Metro E
06571XX0
English
Single Control Lavatory Faucet
Solaris E 06631XX0
Stratos E 06575XX0
Metro E 06571XX0
Solaris E
06631XX0
Stratos E
06575XX0
Metro E
06571XX0
Technical Information
Recommended water pressure 14.7 - 72.5 psi
Recommended hot water temp. 120� - 140� F*
Max. hot water temp 165�F*
Hole size in mounting surface 1-1/4”
Max. mounting surface depth 1 5/8”
Flow rate 2.2 gpm
M3 Cartridge with high temperature limit stop
3/8” supply hoses - requires 3/8” compression fitting (not included)
Listed by IAPMO
Approved for use in Massachusetts
*Please know and follow all applicable local plumbing codes when setting the temperature on the water heater. In
Massachusetts, the water heater may be set no higher than 112oF.
Installation Considerations
For best results, Hansgrohe recommends that this unit be installed by a licensed, profes-
•
sional plumber.
Please read over these instructions thoroughly before beginning installation. Make sure
•
that you have all tools and supplies needed to complete the installation.
The high temperature limit stop may be reset, if desired.
•
2
Installation
Place the faucet and sealing gasket on the mounting surface.
Slide the washer over the bolt. Install the collar.
Tighten the collar with a flat head screwdriver.
English
Secure the supply hoses to the stops with 3/8”
compression fittings (not included).
Use two wrenches, as shown, to keep the
hoses from twisting.
3
English
Install the handle screw on the cartridge stem.
Use a 4 mm Allen wrench to tighten it 4 complete
turns.
Push the handle into place over the screw and
the stem.
Use a 4 mm Allen wrench to finish tightening the
screw.
Install the screw cover.
4X
Install the pull rod.
Install the pop-up drain.
Reset the high temperature limit stop (optional).
4
Install the pop-up drain
English
Remove the plunger assembly.
Unscrew the drain outlet flange from the
tee.
Unscrew the tailpiece from the tee.
Wrap the threads with Teflon tape
and replace.
Install the flexible sealing gasket on the
flange. Sit it in the sink outlet.
From below, install the black mack gasket,
white friction ring, and retainer nut to the
flange. Do not tighten the nut against the
bottom of the sink at this time.
Thread the tee and tailpiece to the flange.
The pivot must face the faucet. If necessary, turn the drain assembly.
Tighten the retainer nut.
Sit the plunger assembly in the drain.
Install the horizontal rod through the pivot
ball seals and into the tee so that the end
goes through the loop in the bottom of the
height adjuster. The two pivot ball seals
should surround the pivot ball.
Slide the link over end of pull rod. Tighten
screw.
Slide one end of spring clip over end of
horizontal rod. Slide link over end of horizontal rod. Test motion of drain plunger.
Reposition link as necessary. There are
multiple holes in the link -- the horizontal
rod may go through any of the holes.
When satisfied with the action of the drain,
slide the other end of the spring clip over
the end of the horizontal rod.
plunger
flange
sealing gasket
mack gasket
friction ring
retainer nut
horizontal
rod
pivot
tee
tailpiece
link
spring
clip
nut
pivot ball
pivot ball
seals
5
Loading...