Hans Grohe 06462XXX User Manual
Installation Instructions / Warranty
Talis
06462XXX
Talis
Single Control Kitchen Faucet
06462XXX
Product Specifications:
Hole size in mounting surface Minimum 1-1/2”
Maximum mounting surface depth 2-3/8”
Flow rate 2.2 GPM
Maximum incoming water pressure 145 PSI
Recommended incoming water pressure 22 - 72.5 PSI
Recommended incoming hot water temp 120o - 140o F*
M3 cartridge with high temperature limit stop
*Some governing bodies require that the water heater be set to 120o F or less. Please know and follow all applicable local
codes when setting the temperature on the water heater.
Installation Considerations
This faucet requires supply stops with 3/8” compression fittings (not included)
Make sure that the faucet is complete and in good condition and that you have all
necessary tools and supplies before beginning installation.
Protection against back siphonage is provided by a check valve in the sprayhead.
Installer: Please leave this manual with the customer as it contains valuable
information on the faucet.
2
Install baseplate 06329XXX,
(optional - not included)
Position the baseplate and gasket on the
faucet deck. From under the sink, install
the mounting flanges and tighten the
mounting collars by hand.
The baseplate can be used on a kitchen
sink with fewer than three holes. Remove
and disgard the threaded studs on the
bottom of the baseplate. Align the
baseplate and the gasket visually.
Install the faucet:
Remove the mounting nut, metal washer,
fiber washer and spacer from the faucet.
Sit the faucet on the mounting surface.
If the mounting surface is thin (less than 1
3/8”) and there is sufficent space, install the
gray plastic spacer. If the mounting surface
is greater than 1 3/8”, or if there is insufficient space, omit the spacer.
Loosely install the fiber washer, metal washer
and mounting nut.
Check the orientation of the faucet. The spout
swivels 150o and should swivel evenly to the
right and to the left. If it is satisfactory, finish
tightening the mounting nut and the tensioning screws.
Install the handspray hose:
slide the nut, cone washer, brass
washer and black rubber washer
over the end of the connecting hose.
Hold the handspray hose steady
while tightening the nut. Do not
allow the handspray hose to
twist. Finish tightening the nut with
a wrench.
3
Loading...