Hansgrohe 06460860, 06461000 Installation manual
Installation Instructions / Warranty
Allegro Kitchen Faucet
06461XX0
Allegro Gourmet Kitchen Faucet
06460XX0
Allegro Kitchen Faucet
06461XX0
Allegro Gourmet Kitchen Faucet
06460XX0
06461XX0
06460XX0
Product Specifications:
Hole size in mounting surface 1-1/2”
Maximum mounting surface depth 2-3/8”
Flow rate 2.2 GPM
Maximum incoming water pressure 145 PSI
Recommended incoming water pressure 22 - 72.5 PSI
Recommended incoming hot water temp. 120o - 140o F*
M3 ceramic mixing cartridge
*Some governing bodies require that the water heater be set to 120o F or less. Please know and follow all applicable local
codes when setting the temperature on the water heater.
2
Installation Considerations
Read all instructions thoroughly before installation. Be sure you have all necessary
tools and supplies available.
Be sure there is sufficient space behind the faucet to allow the handle free movement to the rear.
This unit requires supply stops with 3/8” compression fittings (not included).
Protection against back siphonage is provided by a check valve in the sprayhead.
Installation
Remove the mounting nut, metal washer,
fiber washer and spacer from the faucet.
Sit the faucet with sealing ring on the
mounting surface.
If the mounting surface is thin (less than
1 3/8”) and there is sufficent space,
install the gray plastic spacer. If the
mounting surface is greater than 1
3/8”, or if there is insufficient space,
omit the spacer.
Loosely install the fiber washer, metal washer and mounting nut.
Check the orientation of the faucet. The spout swivels 150o. It should swivel
evenly to the right and to the left. If it is satisfactory, finish tightening the mounting
nut and the tensioning screws.
Install the handspray hose: slide the
nut, cone washer, brass washer and black
rubber washer over the end of the connecting hose. Hold the handspray hose steady
while tightening the nut. Do not allow
the handspray hose to twist. Finish
tightening the nut with a wrench.
3
Loading...