Hanna Instruments HI 3847 User Manual
Instruction Manual
SPECIFICATIONSSPECIFICATIONS
SPECIFICATIONS
SPECIFICATIONSSPECIFICATIONS
INSTRUCTIONSINSTRUCTIONS
INSTRUCTIONS
INSTRUCTIONSINSTRUCTIONS
• It is better to match the color with a white sheet at
about 10 cm behind the comparator.
HI 3847
Copper
Test Kit
www.hannainst.com
SPECIFICATIONSSPECIFICATIONS
SPECIFICATIONS
SPECIFICATIONSSPECIFICATIONS
Dear Customer,
Thank you for choosing a Hanna Product. Please read the
instructions carefully before using the chemical test kit. It
will provide you with the necessary information for correct
use of the kit.
Remove the chemical test kit from the packing material and
examine it carefully to make sure that no damage has
occurred during shipping. If there is any noticeable damage, notify your Dealer or the nearest Hanna office
immediately.
Each kit is supplied with:
• HI 3847-0 Reagent, packets (100 pcs);
• 1 color comparator cube.
Range 0 to 2.5 ppm
Smallest Increment 0.5 ppm
Analysis Method Colorimetric, bicinchoninate
Sample Size 5 mL
Number of Tests 100
Case Dimensions 230x59x70 mm (9.0x2.3x2.8")
Shipping Weight 150 g (5.3 oz.)
SIGNIFICANCE AND USESIGNIFICANCE AND USE
SIGNIFICANCE AND USE
SIGNIFICANCE AND USESIGNIFICANCE AND USE
Copper is an essential trace element in human diet (the
daily requirement is around 2.0 mg) and a factor in plant
metabolism. Copper salts are used in water supply systems
to control biological growth in reservoirs. Corrosion of copper
alloys in pipe fittings on the other hand may introduce
considerable quantities into the water supplies.
Note: mg/L is equivalent to ppm (parts per million).
CHEMICAL REACTIONCHEMICAL REACTION
CHEMICAL REACTION
CHEMICAL REACTIONCHEMICAL REACTION
Copper salts react with bicinchoninate reagent to form a
purple product in a neutral buffered condition. The amount
of color developed is proportional to the concentration of
copper present in the aqueous sample.
READ THE ENTIRE INSTRUCTIONS BEFORE USING THE KIT
• Fill one color comparator cube with 5 mL of the sample
(to the mark).
• Add 1 packet of HI 3847-0, replace the cap and shake
well.
• Wait 45 seconds to allow color to develop.
• Determine which color matches the solution in the vessel
and record the result in mg/L (or ppm) of Copper.
Note: To measure Copper in the 0-0.25 ppm range, use
the HI 3856 Copper Ultra Low Range Test Kit.
REFERENCESREFERENCES
REFERENCES
REFERENCESREFERENCES
Adaptation of EPA approved method.
HEALTH AND SAFETYHEALTH AND SAFETY
HEALTH AND SAFETY
HEALTH AND SAFETYHEALTH AND SAFETY
The chemicals contained in this test kit may be hazardous if
improperly handled. Read Health and Safety Data Sheets
before performing the test.
Note: Any damaged or defective item must be returned in
its original packing materials.
ISTR3847 03/99 PRINTED IN ITALY
Loading...