HANMI TECHWIN TDP-BM-100 Operating Manual

TDP-BM-100

Battery Status Monitor

OPERATING MANUAL

TEL: [phone]

FAX: [phone]

Battery Status Monitor TDP-BM-100

1

Contents

2

2

2

2

3

4
4

6
6

6

7

1. Introduction

2. Characteristics

3. Purpose

4. Basic Specification

5. Configuration and Operation Principle

6. Displaying data and Setting

6-1 Displaying data
6-2 Setting

7. Wiring for terminal block

7-1 Outside view of terminal block
7-2 Explanation of terminal block

8. Electrical wiring

9. Outside dimension

TDP-BM-100 Battery Status Monitor

2

1. Introduction

TDP-BM-100 is the device of emergency monitoring battery status for

magnet system. Emergency battery installed 9 to 18 in series due to output

voltage; therefore, it is difficult to check each battery status.

TDP-BM-100, which is possible to check battery individually, is to find poor

battery to show graph of battery status. In addition, it could be measured

current of charging and discharging to calculate internal resistance value, and

battery manages stably with alarming if set voltage dropped blow setting

level.

2. Characteristics

◆ Realtime monitoring for battery status.

◆ Battery voltage checks intuitive to show as bar graph.

◆ It could distinct battery voltage with bar graph which color changes.

◆ Easy to set with touch panel.

◆ It has function to display status of charging and discharging.

◆ It is possible to measure internal resistance value for each battery.

◆ Output alarm for poor battery.

◆ It could select integral type and discrete type due to installation

condition.

3. Purpose

◆ Status of industrial battery monitoring device.

4. Basic Specification

◆ Input voltage : AC 80 ~ 240[V] single phase or Specific battery

◆ Touch panel : K600+ LCM

◆ Signal output : WARNING (RELAY contact : AC250V/DC30V, 5A)

◆ Quantity for monitoring battery : 19EA (Industrial 12V battery)

◆ Panel communication : RS-422 (※discrete type)

◆ Temperature range for operation : -20~85[℃]

Battery Status Monitor TDP-BM-100

3

5. Configuration and Operation Principle
TDP-BM-100 consists as blow picture. MCU as a key component consists

easily to check display data on touch panel as a graph type about battery
status such as voltage of each voltage, total voltage of battery in series, and
charging current. As well as, fault alarm will occurs to prevent negligent
accident when battery has trouble.

TB

MCU

POWER

Touch

Panel

COM

Amp.

ON/

OFF

A/D

NC NO

Warning Output

Hall CT

Battery Input Current Input

[Pic1] Block diagram

[Photo1] Main board