Hankscraft 5244341 Users Manual

User Manual

Product: RF timer controller
Frequency: 433.83 MHz
Sender: (battery) A23, 12V
Receiver: (battery) 1.5V x 3AA
Load: Up to 1A 120V

1． Summary

Hankscraft RF model 5244341H is a wireless remote timer control circuit, powered by
batteries. The receiver can drive a load up to 1A 120V with an inner 3V relay. Unit has time-delay,
stable, reliable control characteristics and so on. The ultra-distance remote control (10meters
long) meets the need of various application conditions.

2. Usage Instructions
Open the rear cover of the receiver; install the three 5# batteries with 1.5v according to the

power supply direction sign inside battery clip, then close the rear cover. Connect the load
power supply and load to the receiver through the two pins connectors. (See the four wires in
Wiring Diagram).

Note: If the load is droved by DC power, the positive of the load DC power must be connect

to the pin with red wire, accordingly the positive of the load should be connect to the pin with
black wire. The maximum load is 1A 120V.

Each set of the RF 5244341H has is own code so will not interfere with each other even

there are more than two sets working in the same area.

The emitter just start to work to send signal once the button pushed and stop after the button

is released. At the same time, when you push the button, the pilot lamp will light and go out
when it is released.

The receiver keeps standing by. When it gets the signal from the right emitter will turn on the

inner relay and start the time cycle counting. The time cycle is customized which range is from
2s-80s. Once the time cycle is finished, the Relay will turn off and the receiver will wait for next
signal.

3. Main Parameters

Power Supply DC 5.0±1.25V Available Control Distance >10m

Load Voltage AC 120V

Load Current AC 1.0A Action Time 0.5~78(±30%)

4. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions:

(1). This device may not cause harmful interference, and
(2). This device must accept any interference received, including interference that may cause

undesired operation.

5. NOTE:

The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user’s authority to operate the
equipment.

Remote Controllable

Intervals

2.0~80S(±30%)