Page 1
User manual
Foldable fast wireless charger
Parameter specification
Model:
Qi Charging:
Input:
Output:
Transmission Distance:
Conversion rate:
Dimension:
HKWP1110-10Q
WPC Qi standard 1.2.3
5V-2A/9V-1.67A
5V-1A/9V-1.1A
0-10mm
≥72%
128*68*12mm
Indicating status and protection function
1. LED off light: standby
2. LED blue light: charging
3. LED blue light flashes 1s, LED green light flashes 1s,
then LED blue light goes into the normal charging
mode: Power on
LED Indicator light
Quick Start Guide
Instructions
1. Plug the power adapter into the socket.
2. Micro -USB A side connect the power adapter, Micro
-USB cable connect the wireless charging pad.
3. Blue light is wireless charging indicator light.
4. Put the mobile phone which support wireless charging
function on the launch plate correctly, indicator light
charging to green from blue if you remove the mobile
phone, it means the wireless charging pad enter
standby mode.
5. Foldable wireless charger built -in spindle, the panel and
the activities racks can adjust the angle according to the
need (Angle:0-90 degrees).
The charger is controlled by intelligent chip, it can be used
safety for a long time standby.
90°Rotation
AI Plank
Package Contents
• 2-Coils Qi Wireless charger
• Micro USB
• User manual
Charging
area
Rubber
LED
Attention
1. Please do not vigorously extrusion or collision.
2. Please do not dismantle or put it into fire or water when
the product is power on, to avoid shot circuit or leakage.
3. Please do not use it in severe high temperature, high
humidity or corrosive substance, to avoid damage to the
circuit leakage.
4. Please do not put the metal (such as coin etc) on the
charging pad when charging, to avoid damage from
heating.
Noted:
It is import to use a high-quality power supply with at
least 1.5A output for paper operation of the Qi wireless
charger.
FCC Statement
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.This equipment has been tested and found
to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions (1)this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Loading...