
DS-PD2-D15AME
15m DualͲƚĞĐŚ Detector
Diagram references
detect when both PIR and Microwave technologies are Masked. The detector is
sensors.
The Mask is adjustable between 0 to 1M.
/ĨƚŚĞDĂƐŬŝŶŐĂƌĞĂŝƐĞŶƚĞƌĞĚƚŚĞůƵĞ>ƐƚĂƌƚƐŇĂƐŚŝŶŐƚŽƐŚŽǁƚŚĂƚƚŚĞ
MASK and ALARM relay will open and the Green and Orange LEDs will be
and a walk test must be done.
Blocking:
15m when the panel is disarmed. When blocking is detected the alarm relay
blocking, the DS-PD2-D15AME must be walk tested so that the PIR and MW sensors
Blocking Enabled/Disabled: To enable the feature, switch 6 must be OFF
and the RI input should be connected to an output on the control panel which
gives 0V when DISARMED and removes 0V when ARMED.
DS-PD2-D15AME is supplied with the following:
BRACKETW (Wall Bracket), BRACKETC (Ceiling Bracket) and TAMPER
(Back tamper)
NOTE:
remains at 15m.
Coverage 85° 74zones 7planes,Curtain
Maximum range 15m/18m/30m
mal installa on he igh t 1.8-2.4m
Op
on yes
Creep-zone protec
Key features
-masking (an -spray) yes
Adjustable an
blocking technology yes
An
Blue Wave Technology yes
c sensi vity yes
Automa
Digital temperature compensa
Separate indica
3 microwave frequencies to avoid interference yes
DEOL resistors on board yes
Tamper protec
Signal Strength Indicators (SSI) n/a
Wired
Power supply 9-16 DC (12DC nominal)
Current consump
Current consump
Relay type Solid state
Output rela y 60DC, 50mA p rotec
Tamper t ermi nal 12DC max, 50mA max
Electrical speciĮca
Microwav e fr eque ncy 10. 515, 10.525, 10. 535GHz
Alarm response 2.5 second
Detec
Direct light Įlte r 6500 Lux
Op
Geometri c len s conĮgura
Other details
Opera
Weight 125g
Dimen sion s 117 x 69 x 55 mm
Accessories
Wall/ceiling brackets included yes
Long range and curtain lenses included yes
Bracket back tamper kit included yes
Cer
Electrical conformity CE
Warranty 2 years
User Manual
COPYRIGHT ©2018 Hangzhou Hikvision Digital Technology Co., Ltd.
COPYRIGHT ©2018 Hangzhou Hikvision Digital Technology Co., Ltd.
ALL RIGHTS RESERVED.
ALL RIGHTS RESERVED.
wholly, by any means, without the
or implied, regarding to the Manual.
About this Manual
This manual is applicable to video security control panel.
About this Manual
This manual is applicable to detector.
Please use this user manual under the guidance of professionals.
Trademarks Acknowledgement
website
For electrical products sold within the European Community. At the end of the electrical
Please use this user manual under the guidance of professionals.
products life, it should not be disposed of with household waste. Please recycle where
Trademarks Acknowledgement
country. This product operates in a European non-harmonised frequency band. Hereby
at www.pyronix.com/product-compliance.php
Commercial and Light Industrial Environment.
on yes
on: microwave, P IR and alarm yes
on included yes
on at re st 23mA
on in alarm 30mA
ons
on spe ed 0.3 - 3m/s
cs Sealed
on 3D
ng temp eratu re -10°C / + 40°C
Įca ons and warranty
This product and - if applicable - the supplied accessories too are marked with "CE"
and comply therefore with the applicable harmonized European standards listed
on
START
3K
6K8
15K
8K2
12K
MASK/ALARM EOL
LINK
3K
3EOL
A A T T
EOL INPUT 1 COM
1K
3K
15K
5K6
5K6
2K21K6K8
4K7
2K2
4K7
5K6
6K8
2K2
4K7
5K6
6K8
12K
8K2
1K
4K7
2K21K5K6
4K7
2K2
1K
15K
12K
8K2
6K8
5K6
4K7
2K21K6K8
5K6
4K7
2K21K5K6
4K7
2K2
DEOL
A A T T
EOL INPUT 1 COM
1K
1K
2K2
4K7
5K6
3K
15K
12K
1M
MAX
Max: 1M
ч1m
6K8
8K2
30% Mask
1K
1K
1K
5K6
2K2
4K7
2K2
5K6
4K7
4K7
6K8
5K6
2K2
30%
OFF
>1m
N/C
A A T T
EOL INPUT 1 COM
3K
15K
12K
8K2
6K8
5K6
4K7
2K21K6K8
1K
5K6
4K7
2K21K5K6
4K7
2K2
!
The Input voltage should meet both the SELV (Safety Extra Low Voltage) and
the Limited Power Source according to the IEC60950-1 standard. Please refer
to technical specifications for detailed information.
3K
1K
15K
12K
8K2
6K8
5K6
4K7
2K21K6K8
5K6
4K7
2K21K5K6
4K7
2K2
GENERAL WIRING
HIK
HIK CONTROL PANEL
Z1
COM Z2 Z3
3K
15K
12K
8K2
6K8
5K6
4K7
3K
15K
12K
8K2
6K8
5K6
4K7
2K21K6K8
2K21K6K8
1K
5K6
4K7
2K21K5K6
4K7
2K2
1K
5K6
4K7
2K21K5K6
4K7
2K2
3K
15K
12K
GENERAL
GENERIC CONTROL PANEL
Z1
COM Z2 Z3
8K2
6K8
5K6
4K7
2K21K6K8
5K6
4K7
2K21K5K6
1K
4K7
2K2

A A T T
EOL INPUT 1 COM
PGM
NC C NO
Control Panel
Programming
3K
15K
12K
8K2
6K8
1K
5K6
4K7
2K21K6K8
5K6
4K7
2K21K5K6
4K7
2K2
15m Volumetric Lens 30m Long Range Lens18m Curtain Lens
85°
60 zones
Horizontal Coverage
7 planes
Horizontal Coverage at Minimum Range
Horizontal Coverage at Maximum Range
For INCERT compliance,
set pulse count to 1
(see switch 4 diagram)
For INCERT compliance,
set pulse count to 1
(see switch 4 diagram)
Horizontal Coverage
3K
4K7
6K8
5K6
15K
12K
8K2
2K2
4K7
5K6
4K7
2K2
6K8
5K6
2K2
PULSE
COUNT 1
0.25 - 2.5m/s
0.25 - 2.5m/s
1K
1K
1K
AND = OR =

TAMPER
FCC Informaon
Please take aenon that changes or modificaon not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
FCC compliance: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protecon against harmful interference in a residenal installaon. This
equipment generates, uses and can radiate radio frequency energy and, if not installedC and used in accordance with the instrucons,
may cause harmful interference to radio communicaons. However, there is no guarantee that interference will not occur in a parcular
installaon. If this equipment does cause harmful interference to radio or television recepon, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separaon between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help
3K
1K
1K
1K
15K
8K2
6K8
12K
2K2
5K6
4K7
2K2
5K6
4K7
6K8
5K6
2K2
4K7
FCC Condions
This device complies with part 15 of the FCC Rules. Operaon is subject to the following two condions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operaon.
3EOL
3
PCX 162i
Z1 COM
DEOL
2
PCX 162i
Z1 COM
MASK/A LARM EOL
LINK
3EOL
3
Hard Wired Resistor (Generic)
Z1 COM
DEOL
2
Hard Wired Resistor (Generic)
Z1 COM
TAMPER
PIR Activated
Microwave
Activated
Alarm
Mask
Processing
Masked/
Blocked
PIR ALARM MICROWAVE
HORIZONTAL COVERAGE
12m
Powering up
PIR Failed
Self Test
Microwave Failed
Self Test
Low Voltage
O
85
60 zones
7 planes
RLNS074
8k2
6k8
6m
12m
ONLY
Volumetric
Lens
INCERT
3K
15K
12K
8K2
6K8
5K6
4K7
2K21K6K8
5K6
4K7
2K21K5K6
1K
4K7
2K2
3K
15K
12K
8K2
6K8
5K6
4K7
2K21K6K8
5K6
4K7
2K21K5K6
1K
4K7
2K2
3K
15K
12K
8K2
6K8
5K6
4K7
2K21K6K8
5K6
4K7
2K21K5K6
1K
4K7
2K2
3K
15K
12K
8K2
6K8
5K6
4K7
2K21K6K8
5K6
4K7
2K21K5K6
1K
4K7
2K2
VERTICAL COVERAGE
1.8-2M
6m
6m
12m
12m