FCC compliance: Please take attention that changes or modification not expressly
approved by the party responsible for compliance could void the user’s authority to
operate the equipment.
Note: This product has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
product generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this product does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This equipment should be installed and operated with a minimum distance 20cm between
the radiator and your body
Quick Operation Guide of Network Video Recorder
FCC conditions
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may
cause undesired operation.
EU Conformity Statement
This product and - if applicable - the supplied accessories too are marked with "CE" and
comply therefore with the applicable harmonized European standards listed under the
Low Voltage Directive 2006/95/EC, the R&TTE Directive 1999/5/EC, the RoHS
Directive 2011/65/EU.
2012/19/EU (WEEE directive): Products marked with this symbol cannot be disposed of
as unsorted municipal waste in the European Union. For proper recycling, return this
product to your local supplier upon the purchase of equivalent new equipment, or dispose
of it at designated collection points. For more information see: www.recyclethis.info.
Quick Operation Guide of Network Video Recorder
2006/66/EC (battery directive): This product contains a battery that cannot be disposed of
as unsorted municipal waste in the European Union. See the product documentation for
specific battery information. The battery is marked with this symbol, which may include
lettering to indicate cadmium (Cd), lead (Pb), or mercury (Hg). For proper recycling,
return the battery to your supplier or to a designated collection point. For more
information see: www.recyclethis.info.
Quick Operation Guide of Network Video Recorder
Trademarks and Registered Trademarks
Windows and Windows mark are trademarks or registered trademarks of
Microsoft Corporation in the United States and/or other countries.
HDMI, HDMI mark and High-Definition Multimedia Interface are trademarks or
registered trademarks of HDMI Licensing LLC.
The products contained in this manual are authorized by HDMI Licensing LLC
with the use right of the HDMI technology.
VGA is the trademark of IBM.
UPnPTM is a certification mark of the UPnPTM Implementers Corporation.
Other names of companies and product contained in this manual may be
trademarks or registered trademarks of their respective owners.
Quick Operation Guide of Network Video Recorder
Thank you for purchasing our product. If there is any question or request, please do not
hesitate to contact dealer.
This manual is applicable to the model DS-7108NI-E1/V/W.
NVR Pre-Installation
The NVR is highly advanced surveillance equipment that should be installed with care.
Please take into consideration the following precautionary steps before installation of the
NVR.
Keep all liquids away from the NVR.
Install the NVR in a well-ventilated and dust-free area.
Ensure environmental conditions meet factory specifications.
NVR Installation
During the installation of the NVR:
Use brackets for rack mounting.
Ensure there is ample room for cables.
When routing cables, ensure that the bend radius of the cables are no less than
five times than its diameter.
Allow at least 2cm (≈0.75-inch) of space between racks mounted devices.
Environmental temperature should be within the range of 0 ºC ~ +40 ºC (+32 ºF ~
+104 ºF).
Environmental humidity should be within the range of 10% ~ 90%.
Lay the device in a proper way, as shown below.
1
Quick Operation Guide of Network Video Recorder
Main Features
Support establishing wired and wireless network instead of an wireless router.
Support SADP automatically searching and adding active IP cameras.
A build-in noiseless fan supports automatically adjusting speed.
Provide an installed 2.5-inch HDD when delivery.
2
Quick Operation Guide of Network Video Recorder
LAN
3G/4G
UTP Cable
NVR
WIFI Network
Camera
WIFI Network
Camera
Network
Camera
LAN
WAN
HDMI Cable
Base Station
HDMI Displayer
Computer
Phone & laptop
Phone & laptop
Typical Application
3
Quick Operation Guide of Network Video Recorder
Front Panel
The front panel of NVR is shown below:
4
Quick Operation Guide of Network Video Recorder
Rear Panel
The rear panel of NVR is shown below:
5
Quick Operation Guide of Network Video Recorder
No.
Name
Function Description
1
LAN Interface
(1 ~ 3)
3 RJ-45 10 /100Mbps network interfaces for LAN
(Local Area Networks).
2
WAN Interface
1 RJ-45 10 /100 Mbps network interface for WAN
(Wide Area Networks).
3
USB Interface
Universal Serial Bus (USB) ports for additional devices
such as USB mouse and USB writer.
4
HDMI
HDMI video output connector.
5
POWER
12VDC Power supply.
6
Quick Operation Guide of Network Video Recorder
Accessing by Web Browser
You can get access to the device via web browser.
Before you start:
Establish the connection between your computer and the NVR via wired or wireless
network.
Wired network: connect the Ethernet port of computer to the LAN interface of
NVR. And configure the IP address of computer on the principle that the network
segment is the same with NVR, that is 192.168.254.×××.
Wireless network: the default SSID and password of wireless network created by
NVR is in the tag of device.
Logging In
Steps:
1. Open web browser, input the IP address of the device and then press Enter. The
login interface appears.
7
Loading...
+ 30 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.