Hangshi Technology MW162 User Manual

Wireless Mouse
MW162
Instruction
Using area: Tablet PC , Laptop, Desktop Computer. Power on/off : Fold the mouse to turn it on. Unfold the mouse to turn it off.
Pairing steps:
1.Take out the nano receiver from the slot on the buttom case;
2. Plug the nano receiver into an available USB port on your computer;
3. Unfold the mouse to turn it on , now your mouse will connect to your computer automatically.
Specifications
Working Hz: 2.4G Modulation: GFSK
Working current: ≤4.5mA
Awak up: pressing any key
Battery life: 300 times circulation
Standby time: 30 days
DIP resolution rate: 800-1200-1600
Working distance: >8m(open space and straight distance )
Sleeping time: about 10 minutes ( no any pressing )
Voltage: 3.7V
Starting current: ≤12.5mA
Low voltage demand: ≤3.0V
Charging time: 2.5H
Working time: 60H
FCC Warnning:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable condition without restriction.
Loading...