2.4G Mouse
User Manual
Package Contents
1 x Mouse
1 x User Manual
RF Specification
Modulation Type GFSK
Operating Frequency 2405MHz~2470MHz
Number Of Channel 8
Using area: Tablet PC , Laptop, Desktop Computer.
The power supply for Mouse : Use a 3.7Vdc Li-ion battery
Charge Steps for Mouse:
Use the USB cable for charging. Connect one end to a USB charger, and the other to the mouse.
(USB cable and charger is not included)
Pairing steps:
1. Turn the mouse down to turn on the power
Remove the USB Dongle at the bottom and plug it into your laptop or desktop computer.
2.
The dongle only has the receiving function
3. Wait for the laptop or computer to automatically install the driver, then use the mouse
FCC Warnning:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer
could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1)This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
RF Exposure
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This device should be installed and operated with minimum distance 5mm between
the radiator & your body.