Large Square Window
3/4" (1.9cm)
LDR 06/15/06 PL
An easy and attractive way to give any wooden structure its own view on the world
PARTS LIST
Part Qty. Description Size
(LV) 2 Framing 2x3x22-1/2”
(DT) 2 Hor. Trim 1x3x28-1/8”
(DV) 2 Ver. Trim 1x3x30-1/8”
1 Window
1 Hardware Kit
(8) 3/4” Screws; (28) Finish Nails; (8) 3” Nails
1 Window Opening
1. Locate area to install window, making
sure there are no studs or braces in the
way.
2. Mark an opening 22-1/2” wide by 30”
high using outside of dotted line (fig. A-1).
3. Drill 3/8” starter hole in corners. Cut
opening according to marked line (fig. A-2).
4. Place framing (LV) at top and bottom of
cutout flush with opening edges, nail through
studs into framing ends. (fig. C)
5. Position window in opening from outside
the building. Attach window using eight 3/4”
screws (fig. B).
A
Inside View of Wall
30”
(76cm)
22-1/2”
(57cm)
1-800-437-0784
#16600
1
For 6’ wall: 3” below doubler
For 7’ wall: 12” below doubler
2
3/8” Starter
B
2 Window & Trim Installation
2. Position and center vertical window trim
(DV) flush to mid-lip on the window frame.
Secure trim with (6) 4d finish nails, making
sure not to nail through the window flange.
Continue with the other side. Center trim
pieces (DT) and attach with (6) 4d finish nails
per piece.
Note that the horizontal trim (DT) piece
overhangsvertical piece (DV) on the ends by
about 3/8”.
Notice: Caulk window trim (with a
quality, paintable exterior grade caulk)
along sides and across top and bottom.
C
3“ Nails
LV
Inside View
LV
D
DT
DV
DV
Outside View
DT
Loading...