Handol 31, 32, 32A, 31A, 33T Installation Instructions Manual
GB
61
INSTRUCTIONS
Installation
31 31A 32 32A 33T
GB
62
Quality approval
The stove has been tested by the
Swedish National Testing and
Research Institute and meets
the applicable regulations for
CE approval and the stricter
requirements for P marking.
Certificate number for
P Marking: 0112/ 07.
Manufacturer’s assurance
Manufacture of the product
has taken place in accordance
with those documents which are
the basis for the relevant type
approval certification and the
required manufacturing checks.
Requirements for flue
The chimney must be dimensioned for at least 350° C for
both top connection directly
upwards and connection directly
backwards from the rear of the
stove.
Handöl 30 is a Swan marked
wood burning stove.
As the premier stove
manufacturer in Sweden,
we at NIBE Brasvärme are
committed to Swan marking
our stoves. Choosing to Swan
mark our products is one aspect
of our vision to be a company
of the future with equally high
quality standards regarding the
environment.
Certifcate number 378-001.
Certifierad
Certifikat nr
0112/07
NOTE!
Notify the local building authorities of the new installation
Report installation of a stove to your local authority.
The owner of the house is personally responsible for ensuring
compliance with the mandatory safety requirements and must
have the installation approved by a qualified inspector.
Your local chimney sweep must also be informed about the
installation as this will affect the routines for regular chimneysweeping services.
EU-declaration
of conformity
Product covered by this declaration
Product type Stove fired by fixed fuel
Type designation Handöl 30-series
Type acc. to standard SS-EN 13240
Intended for use Heating of living accomodation
Fuels Wood logs
Special conditions None
Manufacturer
Name NIBE AB/NIBE Brasvärme
Address Box 134, Skulptörvägen 10, SE-285 23 MARKARYD
Place of manufacture Markaryd
Manufacturing check by approved organisation
Name Swedish National Testing and Research Institute AB
Address Box 857, SE-501 15 BORÅS
Report no / date -/-
Niklas Gunnarsson
Business area manager NIBE Stoves
Appendices
4--!('3) )-.''.%*))-.,/.%*)-
HANDÖL
In accordance with standards below
marking was affixed:
European Standard:
SE Quality Certification, P-marked:
NO Standard NS 3059:
DE and AT Standard DIN 18.891 and
Art 15a B-VG:
Type:
Nominal Output:
Fuel:
Minimun draught:
Flue gas temerature:
Energy efficiency:
Emission of CO in cumbustion products:
Distance to cumbustible wall (mm):
Follow the user’s instructions and use only recomended fuel
NIBE AB Box 134 SE-285 23 MARKARYD SWEDEN
2007
EN 13240
Cert no 0112/07
SINTEF 110-0275
RRF-40 07 13 90
Handöl 31/31A/32/32A
5 kW
Wood
12 Pa
280°C
78%
0,14%
Behind 150
Beside 450
Corner 150
HANDÖL
In accordance with standards below
marking was affixed:
European Standard:
SE Quality Certification, P-marked:
NO Standard NS 3059:
DE and AT Standard DIN 18 891
and Art 15a B-VG:
Type:
Nominal Output:
Fuel:
Minimun draught:
Flue gas temerature:
Energy efficiency:
Emission of CO in cumbustion products:
Distance to cumbustible wall (mm):
Follow the user’s instructions and use only recomended fuel
NIBE AB Box 134 SE-285 23 MARKARYD SWEDEN
2007
EN 13240
Cert no 0112/07
SINTEF 110-0275
RRF-40 07 13 90
Handöl 33T
5 kW
Wood
12 Pa
280°C
78%
0,14%
Behind 100
Beside 415
Corner 100
378
001
N
O
R
D
I
C
E
C
O
L
A
B
E
L
GB
63
TABLE OF CONTENTS
General 64
Installation distance to walls and ceiling 65
Supply of combustion air 67
Removing the loose components 68
Connection to the chimney 70
Installing the surround, H31/31A/H32/H32A 72
Installing the surround, H33T 74
Installing accessories · Base 76
Installing accessories · Drawer 77
Installing accessries · Wood compartment 79
DEAR HANDÖL OWNER
We welcome you to the Handöl family and hope that you will
gain much pleasure from your stove. We understand that you
place high demands on both quality and design. As a new
owner of a stove from Handöl you have a stove with timeless
design and a long lifetime.
The stove combustion is also environmentally friendly and
efficient for the best heat production.
Read the installation instructions carefully before you begin
installation and the separate lighting and user instructions
before you light the fire.
WARNING!
The stove becomes very hot when lit
During operation, certain surfaces of the stove
become very hot and can cause burn injury if
touched. Be aware of the strong heat radiated
through the hatch glass. Placing flammable
material closer than the safe distance
indicated may cause a fire. Pyre lighting
can cause quick gas ignition with the risk of
damage to property and personal injury.
GB
64
Eldstadsbeklädnad
Rosterreglage
Asklåda
Förbränningsluftsreglage
Brasbegränsare
General
This manual contains
instructions about how
the Handöl 30 series
must be assembled and
installed.
To guarantee the function and safety of the stove we
recommend that it is installed by a professional. Our Handöl
agents can recommend a suitable installer.
Instructions for lighting and use are also supplied with the
stove. Read them carefully and keep them safe for future use.
The stove is type approved and must be connected to a chimney
dimensioned for at least 350°C, the external connection
diameter is Ø150 mm. Supply air from the open air should be
used as combustion air.
Building application
Before installing a stove or erecting a chimney it is necessary
for you to apply for planning permission from your local
authority. Ask your local authority for advice regarding building
regulations and the application.
Structural support
Check that the wood joists are strong enough to bear the weight
of the stove and chimney. The stove and chimney can usually be
placed on a normal wooden joist in a single occupancy house if
the total weight does not exceed 400 kg.
Hearth plate
To protect the floor from any embers the stove must be placed
on a hearth plate. If the floor under the stove is flammable, it
must be protected by a non-flammable material which covers at
least 300 mm to the front and 100 mm on each side.
The hearth plate can consist of natural stone, concrete or 0.7
mm metal. As an accessory, the hearth plate is available in
painted steel.
Chimney
The stove requires a draft in the chimney of at least –12 Pa. The
draught is affected both by the length and area of the chimney,
and by how well sealed it is. Minimum recommended chimney
length is 3.5 m and a suitable cross section area is 150-200 cm²
(140-160 mm in diameter). Carefully check that the chimney is
sealed and that there is no leakage around soot hatches and flue
connections.
Note that a flue with sharp bends and horizontal routing reduces
the draught in the chimney. Maximum horizontal flue is 1 m,
on the condition that the vertical flue length is at least 5 m. It
must be possible to sweep the full length of the flue and the soot
hatches must be easily accessible.
ANVISNING
31 31A 32 32A
33T
installations
I
nstallationsanvisning 2
Installasjonsanvisning xx
I
nstallationsanleitun
g xx
Installation instruction xx
eldnings
instruktion
H
30
Eldningsinstruktion 2
Heizinstruktionen 5
Fyringsinstruksjon 9
Lighting Instructions 13
Fyringsvejledning 17
Instructions d’allumage 21
Lämmity sohjeet 25
Istruzioni per l’accensione 28
Stookinstructies 32
HANDÖL
Technical data
Output 3-7 kW
Nominal output 5 kW
Efficiency level 80%
Model 31 31A 32 32A 33T
Weight (kg) 128 128 128 128 250
Width (mm) 480 480 480 480 550
Depth (mm) 450 450 450 450 460
Height (mm) 1025 1025 1025 1025 1080
The connection’s external diameter is Ø150 mm.
Type approved in accordance with:
European standard EN-13240
Swedish environmental and quality marking,
P-marking cert. no. 0112/07
Norwegian standard NS 3059, SINTEF 110-0275
German standard DIN 18.891, RRF-40 07 13 90
Fire-box surround
Grate shuttle
Ash-pan
Log guard
Air supply control
Type plat e
GB
65
480
Tilluftsstos Ø64
1025
2000
Brännbart tak
513
452
189
Tilluftsstos Ø64
Hål i gjuten fotplatta Ø115
A 956
B 865
D 189
C 60
E 103
F 134
Utv. Ø150
392
Brännbar vägg
150
745
817
289
Brännbar vägg
100
450
400
300
100
300
200
100
690
Tillåtet område för
brännbart material
292
Brandmur
50
645
676
239
Brandmur
50*
50
290
Installation distance to walls and ceiling
Position the stove on a hearth plate and check that the installation distances given
in the diagrams are met. The minimum distance between the stove opening and
combustible parts of the building or décor must be at least 1 m.
When top connecting a steel flue please refer to the relevant manufacturer’s
installation instructions. Observe the safety distances to combustible material that
steel flues require.
H31, H31A och H32 H32A
* To prevent the discolouring of paint ed fire walls, we recommend a side distance the same as for the combustible wall.
A = height from floor to chimney connection
B = height from floor to c /c smoke outlet rear
C = distance from back to smoke outlet rear
D = height from floor to air inlet
E= distance from back to c/ c air inlet
F= distance from back to c /c hole in cast foot plate
Combustible ceiling
Combustible wall
Fire-retardant wall of brick or concrete
Permitted area for
combustible material
.
Combustible wall
Fire-retardant wall of brick or concrete
Air inlet Ø64
Hole in cast foot plate Ø115
Air inlet Ø64
GB
66
551
Tilluftsstos Ø64
1073
2000
Brännbart tak
523
462
199
Tilluftsstos Ø64
Hål i gjuten fotplatta Ø120
A 956
B 868
D 189
C 75
E 117
F 141
Utv. Ø150
366
Brännbar vägg
100
732
781
289
Brännbar vägg
100
415
43
300
200
100
300
400
200
100
690
Tillåtet område för
brännbart material
248
Brandmur
50*
50
326
316
Brandmur
50*
682
710
Installation distance to walls and ceiling
Position the stove on a hearth plate and check that the installation distances
given in the diagrams are met. The minimum distance between the stove
opening and combustible parts of the building or décor must be at least 1 m.
When top connecting a steel flue please refer to the relevant manufacturer’s
installation instructions. Observe the safety distances to combustible material
that steel flues require.
* To prevent the discolouring of paint ed fire walls, we recommend a side distance the same as for the combustible wall.
Permitted area for
combustible material.
Combustible wall
Fire-retardant wall of brick or concrete
Combustible wall
Fire-retardant wall of brick or concrete
H33T
A = height from floor to chimney connection
B = height from floor to c /c smoke outlet rear
C = distance from back to smoke outlet rear
D = height from floor to air inlet
E= distance from back to c/ c air inlet
F= distance from back to c /c hole in cast foot plate
Combustible ceiling
Air inlet Ø64
Hole in cast foot plate Ø120
Air inlet Ø64
Loading...