Handan BroadInfoCom R 200 User Manual
User’s Manual
NB-600 R-200
For Your Safe Biking !!
1. Features
1. Wireless Directional Turn Signal Light
2. Burglar Alarm
3. Automatic Brake Signal Light
4. Safety Tail Light
5. Electric Bell Horn
6. Automatic energy saving mode
- When idle for 5 minutes and bicycle moves, the Lighting unit works again.
- When idle for additional 10 minutes, Lighting unit turns off automatically.
7. Water Resistant
2. Contents on Package
< Lighting unit >
< Lighting Unit Holder &
Angle Adjusting Screw >
< Seatpost
Mounting Holder >
< Mounting
Rubber(Long) >
< RCU >
< Mounting
Holder >
< Mounting
Rubber(Short) >
1
< Instruction
Manual >
< Charging Cable >
3. Overview
1. Lighting unit
2. Remote Control Unit (RCU)
Power Button
- Power on/off (Press a few seconds)
- Tail light mode setting (Press shortly)
Sound Button
- Sound on/off
1. Left/Right Button
- Directional signal light
control (Left / Right)
2. Burglar Alarm Button
- Burglar alarm Arm/Disarm
(Press a few seconds)
- Lamp On/Off (Press shortly)
2
Bell Button
USB connector
(Charging)
Battery Level Indicator
- Charging : LED OFF
- Indicating battery level
- Charged fully : Blue LED
USB connector
(Charging)
Battery Level
Indicator
4. Installation
3
RCU Installation
1. Put the “Mounting Rubber” into round part of the “Mounting Holder” in order to be
tight on the seat post.
2. It is possible to rotate(90 degree) the direction of the RCU for user’s preference.
3. Push “RCU” in the sliding hole of “Mounting Holder” and mount on handlebar or grip.
4. To take out the RCU, pull the unit with pushing the hook of “Mounting Holder”.
Lighting unit Installation
1. Put the “Mounting Rubber” into round part of the “Seatpost Mounting Holder” in order to be
tight on the seat post.
2. After adjusting the favorite angle, assemble “Lighting Unit Holder” and “Seatpost Mounitng
Holder” with “Angle Adjusting Screw”.
3. Install the “Lighting Unit” onto “Seatpost Mounting Holder”. (Refer to the below image.)
4. To take out the lighting unit, pull the unit with pushing the hook of “Lighting Unit Holder”.
[ Picture1 ]
[ Picture2 ]
[ Picture3 ]
[ Picture1 ]
[ Picture2 ]
[ Picture3 ]
Loading...