
SOLAR LED SPOTLIGHT
SKU # 326882
UPC # 873046004840
Thank you for purchasing this Hampton Bay solar light product.
This product has been manufactured with the highest standards
of safety and quality. The finish of this product is weather
resistant but over time will naturally weather and fade.
Questions, Problems, Missing Parts? Before returning to your
local Home Depot, please call our Customer Service Team at
1-877-527-0313. Please reference the SKU # and keep your
receipt for Proof of Purchase.
Save this manual for future reference

PACKAGE CONTENTS
BEFORE YOU START
How solar light works:
Solar light has a solar panel that converts sunlight into electricity.
During the day, the electricity converted by the solar panel is
stored in the rechargeable battery. At night, the solar light is
powered by the battery using the electricity stored during the day.
The operating time depends on geographical location, daily
weather conditions and season.
Choose the right location:
Select a location with full, direct sunlight. Do not install in shady
areas as these areas will not allow the battery to be fully charged
and will reduce nighttime working hours. Be sure that the
selected location is not close to other nighttime light sources such
as street lights or porch lights. These light sources may keep the
solar lights from turning on automatically.
About BrightnessSelector™ Switch:
Refer to the following chart for the two available working modes
controlled by the BrightnessSelector™ switch:
* With a full sunny day charge.
Mode
6H
45 lumens constantly
6 hours
10H
36 lumens in the first 5 hours,
Description Quantity
A Spotlight 1
B Ground Spike 1

FIG.2
FIG.1
ASSEMBLY AND INSTALLATION INSTRUCTIONS
No tools required for assembly and installation.
Step 1
At the bottom of spotlight (1), use
the BrightnessSelector™ switch to
choose a preferred working mode
for your solar lights. (FIG.1)
Step 2
Attach the spotlight (1) to ground
spike (2). Push the assembly firmly
into the ground—DO NOT use a
hammer. For ground with hard soil,
to prevent breaking the ground
spike, use trowel to loose soil first.
(FIG.2)
Charging the battery:
For optimum performance, it is best to install the solar lights in full
sunlight and charge for 10-12 hours. Allow the light to run at least
8-12 entire charging and discharging cycles to reach battery’s
maximum capacity.
REPLACING THE BATTERY
For best performance, replace with rechargeable 3.2V Lithium
Phosphate 1000mAh battery every year or when performance
diminishes.
(1)
(1)
(2)

Push the release tab and remove
the battery compartment cover.
Replace the old battery with a fresh
18500 Lithium Phosphate
rechargeable battery. Replace the
battery compartment cover. (FIG.3)
CAUTION: CONTAINS LITHIUM PHOSPHATE
BATTERY. BATTERY MUST BE RECYCLED OR
DISPOSED OF PROPERLY.
TROUBLESHOOTING AND TIPS
If your solar light does not turn on at night or its nightly run time is
shorter, it may be caused by one of the following conditions:
1. Battery is not fully charged. Make sure the solar light is
located in an area where it can receive the maximum amount
of full, direct sunlight everyday. If the solar light does not
receive enough sunlight during a day (e.g. due to cloudy or
overcast weather conditions), it will be recharged on the next
sunny day and resume normal operation. Keeping the solar
panel clean is equally important to ensure the maximum
charging performance.
2. The solar light is installed close to other light sources, which
may keep the solar light from turning on at night
automatically. To solve the problem, relocate the fixture or
eliminate other light sources.
3. The battery is reaching the end of its useful life and needs to
be replaced.
Winter tips:
Keep debris and snow off the solar panel to allow the battery to
recharge. If lights have been covered by snow for a long time,
allow batteries to recharge in full, direct sunlight for at least 10-12
hours so they can maintain maximum capacity.
FIG.3
(1)

LIMITED WARRANTY
The Manufacturer warrants this product to be free from defects in
materials and workmanship for a period of two (2) years from
date of purchase. This warranty applies only to the original
consumer purchaser and only to products used in normal use
and service. If this product is found to be defective, the
manufacturer's only obligation, and your exclusive remedy, is the
repair or replacement of the product at the manufacturer's
discretion, provided that the product has not been damaged
through misuse, abuse, accident, modifications, alterations,
neglect or mishandling. This warranty shall not apply to any
product that is found to have been improperly installed, set-up, or
used in any way not in accordance with the instructions supplied
with the product. This warranty shall not apply to a failure of the
product as a result of an accident, misuse, abuse, negligence,
alteration, or faulty installation, or any other failure not relating to
faulty material or workmanship. This warranty shall not apply to
the finish on any portion of the product, such as surface and/or
weathering, as this is considered normal wear and tear. The
manufacturer does not warrant and specially disclaims any
warranty, whether expressed or implied, of fitness for a
particular purpose, other than the warranty contained herein.
The manufacturer specifically disclaims any liability and
shall not be liable for any consequential or incidental loss or
damage, including any labor / expense costs involved in the
replacement or repair of said product.
Printed in China
Ver. 1.0