HAMPTON BAY 19348 Use And Care Manual
Item #221-882
Model #19348
USE AND CARE GUIDE
SIENNA 3-TIER FOUNTAIN
Questions, problems, missing parts? Before returning to the store,
call Hampton Bay Customer Service
8 a.m. - 6 p.m., EST, Monday-Friday
1-877-527-0313
HAMPTONBAY.COM
THANK YOU
We appreciate the trust and confidence you have placed in Hampton Bay through the purchase of this fountain. We strive to continually create quality
products designed to enhance your home. Visit us online to see our full line of products available for your home improvement needs. Thank you for
choosing Hampton Bay!
Table of Contents
Table of Contents .......................................................... 2
Safety Information ......................................................... 2
Warranty ......................................................................... 3
Pre-Assembly ................................................................ 3
Planning Assembly ...................................................................3
Package Contents ....................................................................4
Safety Information
1. The National Electric Code requires that a ground fault
circuit interrupter (GFCI) be used in the branch circuit
supplying the fountain pump and other pond equipment. See
your electrical supplies dealer for this device.
2. Use only a UL-approved extension cord of the correct rating
to avoid overheating.
3. The fountain is for outdoor decorative use only and is
designed to function with water only.
4. This fountain pump is not intended for commercial use.
5. The water in the fountain is not safe to drink.
6. Do not pull on, carry, or pick up the pump by the electrical
cord.
DANGER: To reduce the risk of electrical shock, always
disconnect the power supply before working with the
fountain.
DANGER: If the plug or your wall receptacle gets wet, due
to water dripping down the power cord or any other reason,
do not remove the plug from the wall outlet until the circuit
breaker is turned off.
DANGER: If the fountain falls into the water accidentally,
turn off the circuit breaker immediately.
WARNING: Do not tamper with the pump/cord assembly.
Pump model number: PT606LB
WARNING: Connect the fountain only to a grounded
outdoor power outlet of 120V- 60Hz.
WARNING: Do not use the pump in flammable liquids or
in sewage where flammable gases are likely to occur.
WARNING: Do not operate the fountain if the pump has
been dropped or has a damaged power cord or plug. Do not
attempt to repair a damaged power cord. Request a
replacement cord from your supplier.
Assembly ....................................................................... 5
Operation ....................................................................... 7
Maintenance .................................................................. 8
Care and Cleaning ........................................................ 8
Troubleshooting ............................................................ 8
WARNING: Children can fall into the fountain and drown.
Keep children and small pets away from the fountain if it
contains any amount of liquid.
CAUTION: Do not leave a running fountain unattended.
CAUTION: Do not use the pump in vehicles, on board
ships, or in an aircraft.
CAUTION: Do not use the pump in a swimming pool.
CAUTION: Change the water regularly to prevent the
proliferation of mosquitos.
CAUTION: Do not use attachments which are not
provided by the manufacturer since they may cause
an unsafe condition.
IMPORTANT: Keep the power cord away from high
temperatures or heat sources.
IMPORTANT: Only use the fountain with the pump,
transformer, and adapter provided.
IMPORTANT: Do not place any items on the edge of the
bowl, such as a potted plant. Excessive weight or pressure
on any of the fountain sections may cause it to tip or fall
over.
IMPORTANT: Do not use the pump for industrial
purposes.
IMPORTANT: Keep the plug dry. Do not expose the plug
to water or steam.
IMPORTANT: Allow the pump power cord to hang
at a lower level than the wall outlet to form a “drip
loop”. This prevents water from dripping down the
power cord and getting into the wall outlet.
2
Warranty
LIMITED WARRANTY
If this product fails due to a defect in materials or workmanship at any time during the first one year of ownership, the manufacturer will
replace it free of charge, postage-paid at their option. This warranty does not cover products which have been abused, altered, damaged,
misused, cut, or worn. This warranty does not cover use in commercial applications. The manufacturer disclaims all other implied or
express warranties including all warranties of merchantability and/or fitness for a particular purpose. As some states do not allow
exclusions or limitations on an implied warranty, the above exclusions and limitations may not apply. This warranty gives you specific legal
rights, and you may have other rights that vary from state to state.
This warranty is limited to the replacement of defective parts only. Labor charges and/or damage incurred during installation, repair,
replacement as well as incidental and consequential damages connected with the above are excluded. Any damage to this product as a
result of neglect, misuse, accident, improper installation or use other than the purpose SHALL VOID THIS WARRANTY.
Contact the Customer Service Team at 1-877-527-0313 or visit www.HamptonBay.com.
Pre-Assembly
PLANNING ASSEMBLY
Read all instructions in this manual before assembly and operation of this product.
To avoid damage to the fountain, assemble it on a soft, non-abrasive surface such as carpet or cardboard.
IMPORTANT: Place your fountain in a location where any
splashing from the fountain will not cause damage.
3 HAMPTONBAY.COM
Please contact 1-877-527-0313 for further assistance.
Pre-Assembly (continued)
A
PACKAGE CONTENTS
I
H
G
F
E
D
Part Description Quantity
Base 1
B Large bowl support 1
C Large bowl 1
D Pump 1
E Pump housing 1
F Medium bowl 1
G Upper bowl support 1
H Small bowl 1
I Finial 1
C
B
A
4
Assembly
Assembling the fountain base
1
□ Place the base (A) on a firm and level surface.
□ Place the large bowl support (B) on top of the base (A) and
twist clockwise to secure in place.
□ Place the large bowl (C) on top of the large bowl support (B)
and twist clockwise to secure in place.
B
C
Installing the pump
2
□ Thread the power cord of the pump (D) down through the
center of the large bowl (C) to the bottom of the base (A).
□ Pull the cord through the hole in the bottom of the base (A).
□ Place the pump (D) in the center of the large bowl (C).
□ Position the pump housing (E) over the top of the pump (D)
so that it sits in the center of the large bowl (C) and twist
clockwise to secure in place.
E
D
C
B
A
A
5 HAMPTONBAY.COM
Please contact 1-877-527-0313 for further assistance.
Assembly (continued)
Assembling the upper fountain
3
body
□ Place the medium upper bowl (F) on top of the pump
housing (E) and twist clockwise to secure in place.
□ Place the small upper bowl support (G) in the center of the
medium upper bowl (F) and twist clockwise to secure in
place.
□ Place the small upper bowl (H) on top of the upper bowl
support (G) and twist clockwise to secure in place.
H
G
F
E
Connecting the pump to the hose
4
□ Thread the hose attached to the bottom of the finial (I) down
through the center of the upper fountain assembly until it
reaches the location of the pump (D).
□ Carefully raise the pump housing (E) and connect the hose
to the pump outlet (D).
□ Carefully lower the pump housing (E) back into place.
□ Place the finial (I) on top of the fountain.
D
C
I
H
G
F
E
C
Filling the fountain with water
5
□ Using clean and clear water, fill the large bowl (C) until the
pump (D) is fully submerged. The large bowl (C) should be
75% full at minimum. The pump will not work if it is not
completely submerged at all times.
D
C
6
Operation
Turning on the pump
1
□ Plug the electrical cord of the pump (D) into a GFCI outlet.
□ After a few moments, water begins to flow. To adjust the
flow rate, adjust the water flow knob or slider located on
the pump (D).
NOTE: Splashing can occur if the flow rate is too high or the
reservoir is too full.
D
C
7 HAMPTONBAY.COM
Please contact 1-877-527-0313 for further assistance.
Maintenance
WARNING: To reduce the risk of electric shock, always
disconnect the power supply before working on the
fountain.
CAUTION: Never run the pump dry. Always keep the
pump fully submerged in water. Failure to do so will cause
irreversible damage to the pump.
□ During the summer months, regularly check the fountain reservoir for water evaporation and refill as necessary.
□ Keep the water clean at all times by frequently checking for debris in the reservoir.
□ Periodically change the water.
□ Periodically check the pump hose and ensure that it is free from dirt and debris.
Care and Cleaning
□ Clean the fountain reservoir and pump’s outlet nozzle with a damp cloth.
□ Store the fountain in a dry and covered location during the winter to prevent freezing.
Troubleshooting
Problem Probable Cause Solution
The pump will not run. There is a faulty circuit breaker. Check the circuit breaker.
There is a faulty outlet. Try another GFCI outlet.
There is not enough water in the fountain. Check the water level in the fountain.
The flow control is low. Check the setting on the pump’s flow control.
The pump is clogged Check the pump discharge intake for dirt and
The fountain is clogged. Check the fountain tubing for kinks and
The pump is air locked. Plug and unplug the pump several times.
debris.
obstructions.
8
Questions, problems, missing parts? Before returning to the store,
call Hampton Bay Customer Service
8 a.m. - 6 p.m., EST, Monday-Friday
1-877-527-0313
HAMPTONBAY.COM
Retain this manual for future use.
Loading...