Hamilton Beach HJ580SA, HJ580SA-S Operation Manual
HJ580SA/
HJ580SA-S
Wireless Speaker System for your iPod
®
Operation Manual
©2009 Hamilton Beach Brands, Inc.
Hamilton Beach® is a trademark of Hamilton Beach Brands, Inc. used uder license by
Starlite Consumer Electronics (USA) Inc.
IPB125 HJ580SA eng 09.indd 1 2009/4/20 11:32:51 AM
2
CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER
(OR BACK). NO USER-SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
The lighting ash with arrowhead symbol, within an equilateral triangle, is intended to alert the
user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that
may be of sufcient magnitude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user to presence of
important operating and maintenance (servicing) instructions in the literature accompanying
the appliance.
The symbol for Class II (Double Insulation)
WARNING
To prevent re or shock hazard, do not expose this appliance to rain or moisture.
The apparatus should not be exposed to dripping or splashing. Objects lled with liquids, such as vases,
should not be placed on the apparatus.
The ventilation should not be impeded by covering the ventilation openings with items, such as
newspapers, table-cloths, curtains, etc.
Naked ame sources, such as lighted candles, should not be placed on the apparatus.
The electrical outlet plug is used as the disconnect device. The disconnect device should remain
readily operable.
In order to disconnect the apparatus from the electrical outlet completely, the electrical outlet plug
should be disconnected from the electrical outlet completely.
Excess sound pressure from earphones and headphones can cause hearing loss.
CAUTION
TO PREVENT ELECTRIC SHOCK, DO NOT USE THIS PLUG WITH ANY EXTENSION CORD, OR
OTHER OUTLET UNLESS THE PLUG CAN BE FULLY INSERTED WITHOUT EXPOSING ANY
PARTS OF THE BLADES.
FCC IMPORTANT
Since the system circuitry may cause interference with other radio tuners nearby, switch this player off
when not in use or move it away from an affected radio tuner.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesirable operation.
Warning: Changes or modications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE:
THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED
BY UNANTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD
VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency to radio communications. However, there is no guarantee that interference will not
occur in a particular installtion. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio / TV technician for help.
This Class B digital apparatus complies with Canadian ICES-003.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
IPB125 HJ580SA eng 09.indd 2 2009/4/20 11:32:53 AM
3
VOL
VOL
ON / OFF
IR
DC IN 9V
1
2
1
3
4
5
CONTROLS AND INDICATORS
BASE UNIT
• iPod® docking
• Speaker Set Battery charger
• RF signal transmitter
1. RF Antenna
2. Battery Charge Contacts
3. iPod® Dock
4. VOL – Button
5. Standby / On Button
6. VOL + Button
7. Remote Sensor
8. AUX LED Indicator
9. iPod® LED Indicator
10. Audio Out Jack
11. AUX In Jack
12. DC In 9V Jack
SPEAKER SET
• With built-in rechargeable battery
1. Speakers
2. • Remote Sensor
• Power / Charge LED Indicator*
• Signal LED Indicator
3. DC In 9V Jack (not for rechargeable battery)
4. Battery Charge Contacts
5. Speaker Power On / Off switch
*STATUS OF LED INDICATIORS FROM SPEAKER SET
When it is placed onto Base Unit:
• Green and Blinking - Battery of Speaker Set is fully charged.
• Red - Battery of Speaker Set is being charged.
When it is detached from Base Unit:
• Green - Speaker Set is working normally.
• Orange and Blinking - receiving signal is weak or out of range.
• Red and Blinking - Battery of Speaker Set is low.
Note: The “DC IN 9V” jack from Speaker Set is not for use in charging battery. When
DC 9V is plugged in, it provides the option to power up the Speaker Set in case
the battery is low or not charged properly.
IPB125 HJ580SA eng 09.indd 3 2009/4/20 11:32:54 AM
4
2
1
3
4
7
8
5
6
REMOTE CONTROL HANDSET
1. IR Transmitter
2. Standby / On Button
- ON and OFF the system
3. Function Button
- Selects source input, iPod® and AUX IN
4. Skip Button
- Skip or fast backward while iPod® is playing
5. Volume + Button
- Increases volume level
6. Volume – Button
- Decreases volume level
7. Play/Pause Button
- Play and Pause iPod® play
8. Skip Button
- Skip or fast forward while iPod® is playing
REMOTE CONTROL BATTERY INSTALLATION
1. Slide the battery compartment out.
2. Install 1x CR2032 battery (3V) into the remote,
paying attention to the polarity diagram in the battery
compartment.
3. Replace the battery compartment.
Note :
1. Weak batteries can leak and severely damage the
remote control unit.
2. This unit comes with a battery. Pull out the insulation sheet to begin use.
BATTERY PRECAUTIONS
Follow these precautions when using battery in this device:
1. The batteries (battery pack or batteries installed) shall not be exposed to excessive
heat such as sunshine, re or the like.
2.
Do not attempt to recharge, short-circuit, disassemble, heat or throw the battery into a re.
3. If the device is not to be used for a long period of time, remove the batteries to prevent
damage or injury from possible battery leakage.
4. Do not try to recharge batteries that are not intended to be recharged as they could
overheat and rupture. (Follow battery maufacturer’s directions.)
5. Dispose of batteries properly in accordance with local laws.
AC Adapter Operation
1.
Insert the DC plug, at the end of the adapter cord, into the DC input jack on the product.
2. Plug the AC adapter into an AC power outlet. Only use with the recommended
9V - 2.2A AC adapter and make sure the local voltage corresponds to adapter’s required
AC input voltage.
MAIN POWER SUPPLY
Check that the power voltage as shown on the type plate corresponds to your local power
voltage. If it does not, consult your dealer or service organization.
IPB125 HJ580SA eng 09.indd 4 2009/4/20 11:32:57 AM