HAMAMATSU C4675-302, C4675-102 Datasheet

PHOTODIODE
16 × 16 element photodiode array detector
C4675 series
2-D detector using 256-element photodiode with visible sensitivity
C4675 series is a two-dimensional detector using a 16 × 16 (256) element Si PIN photodiode array that has high sensitivity in the visible range. Current-to-voltage conversion amplifiers in the signal amplifier section are connected in parallel to each element of the photodiode array, thereby allowing high-speed parallel signal processing. C4675 series is also designed to suppress the power consumption so it operates from two power supplies (±15 V).
Features
l
Wide spectral response: 400 to 1000 nm
l
Wide active area: 17.45 × 17.45 mm
l
Frequency response C4675-102: DC to 1 kHz
l
Parallel signal output by current-to-voltage amplifier
l
Low power consumption: 2.5 W Typ.
General ratings
Parameter Rating Unit
Photodiode Si PIN photodiode array (Made by Hamamatsu S4529) ­Number of element 16 × 16 (256) ­Active area (per 1 element) 0.95 × 0.95 mm Element pitch 1.1 mm Output type Current-to-voltage conversion method, 256-ch parallel analog voltage output ­Dimensional outline 136 (W) × 136 (H) × 153.5 (D) mm Weight 2.1 kg
Absolute maximum ratings
Parameter Symbol Value Unit
Operating temperature Topr 0 to +50 °C Storage temperature Tstg -10 to +60 (no condensation) °C Supply voltage Vs ±18 V
C4675-302: DC to 3 kHz C4675-103: DC to 10 kHz
Applications
l
Nerve potential measurement under microscope
l
2-D (wavelength × spatial position) spectrophotometry in visible range
l
Fine-modulation light measurement
Electrical and optical characteristics (Typ. Ta=25 °C)
Parameter Symbol C4675-102 C4675-302 C4675-103 Unit
Spectral response range Output uniformity - ±15 % Amp gain - 10 Frequency response - DC to 1 k DC to 3 k DC to 10 k Hz Supply voltage Vs ±15 V Current consumption P 2.5 W
Construct device
Product name Type No. Number Note
Two-dimensional detector C4675 series 1 Dedicated cable 8840S-080-174AD-150-W 4 Made by KEL, length 1.5 m Output connector 8850-080-170SD 4 Made by KEL, on-board straight installation type
λ
8
400 to 1000 nm
5 × 10
7
10
7
V/A
16 × 16 element photodiode array detector
C4675-xxx
C4675 series
Spectral response
0.6
0.5
0.4
0.3
0.2
PHOTO SENSITIVITY (A/W)
0.1
0
400
300
500
QE=100 %
600 700 800 900 1000
(Ta=25 ˚C)
QE=50 %
1100
F requency response
10
0
-10 C4675-102
-20
RELATIVE OUTPUT (5 dB/div.)
-30
C4675-302
10.1
(Typ. Ta=25 ˚C)
C4675-103
10 100
FREQUENCY (kHz)
WAVELENGTH (nm)
KACCB0001EA
Measurement method for frequency characteristics
The LED output was adjusted so that the output voltage Vo from C4675 series is set to 5 V. Under this condition, the output of C4675 series was monitored by FFT while sweeping the LED drive frequencies.
KACCB0002EB
LED
HAMAMATSU
C4675-xxx
Vo
FFT
SWEEP
GENERATOR
KACCC0002EA
Loading...
+ 2 hidden pages