Hama 80492 User manual [ml]

080492

Induction Charger“Twin”

Induktionsladegerät

00

Operating Instructions

Bedienungsanleitung

GB

D

A

1

2

B

G Operating instruction

Controls and Displays

1. Connection Socket

2. Status-LED

Thank you for choosing a Hama product.
Take your time and read the following instructions and information
completely. Please keep these instructions in a safe place for
future reference. If you sell the device, please pass these operating
instructions on to the new owner.

1. Explanation of Warning Symbols and Notes

Warning

This symbol is used to indicate safety instructionsortodraw
your attention to specic hazards and risks.

Note

This symbol is used to indicate additional information or
important notes.

2. Package Contents

• Twininduction charger

• Power supply unit

• Connection cable

• These operating instructions

2

3. Safety Notes

• The product is intended for private, non-commercial use only.

• Protect the product from dirt, moisture and overheating, and only

use it in a dry environment.

• Do not drop the product and do not expose it to any major
shocks.

• Do not operate the product outside the power limits given in the
specications.

• Do not open the device or continue to operate it if it becomes
damaged.

• Do not use the product in areas where the use of electronic
devices is not permitted.

• In order to prevent damage caused by overheating, make sure the
product is not covered by textiles, metal or other objects.

• Dispose of packaging material immediately according to locally
applicable regulations.

• Do not modify the product in any way. Doing so voids the
warranty.

Warning

• Only connect the product to a socket that has been approved
for the device. The socket must be installed close to the
product and easily accessible.

• Do not continue to operate the device if it becomes visibly
damaged.

Do not put any bank cards or similar cards with magnetic strips,
or other magnetically sensitive objects, on the product. The data
on the cards could be damaged or deleted.

3

4. Getting Started and Operation

Note

• For charging a terminal device with the induction charger,
your terminal device has to be compatible with the induction
charging technology. Please read the operating instructions
of your device.

• Please note that mobile phone sleeves, covers, etc. and other
materials between the induction charger and the backside of
your terminal device disturb or prevent actually the charging
process.

• Connect the included connection cable to the socket (1) on the
induction charger and the included power supply unit.

• Switch on the induction charger by plugging the power supply
unit into a power outlet approved for this purpose.

• When the power supply is active, the status LEDs (2) light up.

Warning

• Only use suitable charging devices or USB connections for
charging.

• As a rule, do not use charging devices or USB connections that
are defective and do not try to repair them yourself.

• Put your terminal device(s) on the induction charger (B) with the
back to the charger.

• Charging starts as soon as an effective induction eld has been
generated. The system emits an acoustic signal. The relevant
status LED (2) starts to ash. The current charging status
appears on your terminal device.

• If no connection can be established through induction, you may
have to change the position of your terminal device (B).

4

• Charging stops automatically once your device’s battery is fully
charged.

• Remove your terminal device(s) from the induction charger and
disconnect the charger from the power supply.

5. Care and Maintenance

Only clean this product with a slightly damp, lint-free cloth and do
not use aggressive cleaning agents. Make sure that water does not
get into the product.

6. Warranty Disclaimer

Hama GmbH & Co. KG assumes no liability and provides no
warranty for damage resulting from improper installation/mounting,
improper use of the product or from failure to observe the operating
instructions and/or safety notes.

7. Service and Support

Please contact Hama Product Consulting if you have any questions
about this product.
Hotline: [phone] (German/English)
Further support information can be found here:
www.hama.com

8. Technical Data

Induction Charger

Input 5V max. 2,4A

Output 5V max. 2A
Power supply

unit

IN: 100-240V ~ 50/60Hz

OUT: 5V max. 2.4A

5

9. Recycling Information

Note on environmental protection:

After the implementation of the European Directive
2012/19/EU and 2006/66/EU in the national legal system,
the following applies: Electric and electronic devices as
well as batteries must not be disposed of with household

waste. Consumers are obliged by law to return electrical
and electronic devices as well as batteries at the end of their service
lives to the public collecting points set up for this purpose or point of
sale. Details to this are defined by the national law of the respective
country. This symbol on the product, the instruction manual or the
package indicates that a product is subject to these regulations. By
recycling, reusing the materials or other forms of utilising old
devices/Batteries, you are making an important contribution to
protecting our environment.

10. Declaration of Conformity

Hama GmbH 8 Co. KG hereby declares that the device

complies with the essential requirements and other

relevant provisions of Directive 2014/53/EU.
See www.hama.com for the declaration of conformity with the
relevant directive.

6