Haltian TSPRE TPR User Instructions

TPR USER INSTRUCTIONS

1. INTENDED USE OF TPR

TPR is used for movement detection of humans and animals. Detection is based on
PIR (Passive Infra Red) technology. Resulting data is sent wirelessly to a Wirepas
protocol mesh network. The device has also sensors for temperature and
acceleration and it includes an LED for indication purposes. Typically TPR is used
together with MTXH Thingsee Gateway in use cases where the measurements are
performed in several locations and this data is wirelessly collected and sent via 2G
cellular connection to a data server / cloud.

2. GENERAL

Place two AAA batteries (recommended model Varta Industrial) inside the device,
the correct direction is shown on the PWB. Plus sign indicates the positive node of
the battery.

Snap the B cover in place. The device starts making measurements with all the
sensors. Measurements are made once a minute (default, can be changed by
configuration).

The device starts seeking any other nearby devices having the same pre­programmed Wirepas network ID as the device itself. If it finds any, it connects to
this Wirepas network and starts sending measurement results from all the sensors
to the network once a minute (default, can be changed by configuration).

3. INSTALLATION GUIDELINES

Remove the cover
tape from here

The device B cover has a double-sided tape which can be used for attachment;
remove the cover tape and attach the device to the desired position for
measurement. The surface for attachment needs to be flat and clean. Press the
device from both sides for 5 seconds to make sure that the tape is correctly
attached to the surface.