Halsey Taylor XP8W-Q User Manual

This water cooler is certified to

NSF/ANSI 61.

GENERAL

Self-contained, electric refrigerated,
free-standing water cooler designed to be
easily accessible to able-bodied individuals.
Unit is certified to NSF/ANSI 61 and meets
requirements of the Safe Drinking Water Act.
Unit provides 50° F water at 80° F inlet water
and 90° F ambient.

CABINET

Stainless steel panels resist wear and corrosion.
Durable Satin Finish helps hide water spots
and fingerprints.

COOLER TOP

Non-corrosive stainless steel cooler top, number
300 series with satin finish resists stains and
corrosion and is easy to maintain. Anti-splash
ridge reduces splatter. Contoured to insure
proper drainage.

BUBBLER

Exclusive one-piece, chrome-plated two-stream
mound-building bubbler with non-removable
anti-squirt feature and integral hood insures a
satisfying drink of water.

AUTOMATIC STREAM HEIGHT REGULATOR

Self-closing assembly is located inside unit to
prevent tampering. Unit resists corrosion and
liming. A constant stream height is automatically
maintained under line pressures that vary from
20 to 105 psi.

INLET STRAINER

Easily cleaned in-line strainer screen traps
particles of 140 microns or larger before they
enter the waterway.

TEMPERATURE CONTROL

Positive sensing thermostat for controlling
temperature of storage tank water. Factory set
at 50° F Adjustable ± 5° F.

STORAGE TANK

Non-pressurized stainless steel
evaporator/storage tank for long life.
Waterways are certified to NSF/ANSI 61,
far exceeding the requirements of the
Safe Drinking Water Act.

REFRIGERATION SYSTEM

Hermetically sealed, positive start compressor
with lifetime lubrication and built-in overload
protection, efficient capillary sizing, large
capacity dryer-strainer, and self-lubricated fan
cools copper/aluminum condenser. System
uses R134A refrigerant. Protected by Halsey
Taylor’s Limited 5 Year Warranty.

VENTILATION

Insure proper ventilation by maintaining
6" (152mm) minimum clearance from
cabinet louvers to wall.

SUGGESTED SPECIFICATIONS

Shall be floor-standing explosion proof type
cooler for extreme conditions, including areas
where excessive heat, dust and hazardous
atmospheres are present. Shall deliver 8.0 GPH
of 50° F water at 90° F ambient and 80° F inlet
water. Shall have stainless steel basin with
removable drain strainer. Bubbler shall be
two-stream, mound-building type. Separate
valve and automatic stream regulator shall be
mounted within cabinet. Refrigeration system
shall employ high efficiency, positive start
compressor using R134A, non-pressurized tank
with totally encapsulated insulation and be
controlled by positive sensing thermostat.
The manufacturer shall certify the unit to meet
the requirements of NSF/ANSI 61, and the
Safe Drinking Water Act. Unit complies with
ARI Standard 1010.

NOTE: Continued product improvement makes
specifications subject to change without
notice. See Halsey Taylor website for most
current spec sheet.

Stainless Steel Finish Only

Optional Accessories (extra cost)

■■

Water Filter

Trap and service stop not included.

HALSEY TAYLOR, 2222 CAMDEN COURT, OAK BROOK, ILLINOIS 60523

C16 / 8-2007

MODEL XP8W-Q

XP EXPLOSION PROOF COOLER

Model GPH Capacity Base F.L. Shipping Rated
No. Cooled to 50° F* Rate Amps Weight Watt

Ambient Air Temp

Cap. lb. Usage

70°F 80°F 90°F

†

100°F

XP8WQ 8.0 8.0 8.0 8.0 8.0 4.0 84 370

* With projector service and tap water at 80° F

†

UL listed and complies with ARI Standard 1010

Free-Standing Cooler

Explosion Proof

halseytaylor.com

JOB NAME:

ENGINEER/CONTRACTOR NAME:

APPROVAL:

DATE:

Printed in the U.S.A.

XP8W-Q

Explosion Proof
Free-Standing Cooler

(CONTINUED)

PLUMBING CONNECTIONS

Waste and supply lines through back of cabinet.
Waste 1

1

/4" IPS. Supply 3/8" copper.

Trap and service stop not included.

OPERATING PRESSURES:

Supply water - 105 psi maximum

ELECTRICAL

Standard 120 volt, 60 Hz, single phase.
Requires

1

/2" IPS rigid conduit into junction box

inside cabinet (hole provided).

MODEL APPLICATION
Reference

National Electrical Code NFPA No. 70; ASA C1.
Article 500 Hazardous Locations. Listed by
Underwriters Laboratories under Water Coolers
for Hazardous Locations in following classes
and groups.

Flammable Gases or Vapors

Class 1 Group C - atmospheres containing
ethylether vapors, ethylene, or cyclopropane.
Class 1, Group D - atmospheres containing
gasoline, hexane, naphtha, benzine butane,
propane, alcohol, acetone, benzol, lacquer
solvent vapors, or natural gas.

Combustible Dust

Class 2 Group E - atmospheres containing
metal dust, including aluminum, magnesium,
and their commercial alloys.
Class 2, Group F - atmospheres containing
carbon black, coal or coke dust.
Class 2, Group G - atmospheres containing
flour, starch, or grain dust.

Ignitible Fibers

Class 3 - where easily ignitible fibers or flyings
are present.

NOTE: Includes Division 1 and 2 of each Class

shown above. (See reference above.)

SIDE VIEW

FRONT VIEW