Halsey Taylor S-300-CB User Manual
OLD STYLE HOT WATER TANK
USED ON MODEL S-300-CB
CUT
CUT
HOT TANK DRAIN
OLD STYLE HOT WATER TANK
USED ON MODELS SCWT-CB AND WM-CB
TO DRAIN
HOT TANK DRAIN
CUT
CUT
PAGE 1 92534C (REV. C - 9/02)
NEW STAINLESS STEEL
HOT WATER TANK KIT
TO DRAIN
TO HO T TANK THERMOSTAT
TO COLD CONTROL
VENT
HOT WATER
OUT
5
1
WATER IN
WATER TO
HOT TANK
3
5
2
TO COLD CONTROL
6
7
4
TO COMPRESSOR
HALSEY TAYLOR HOT TANK REPLACEMENT INSTRUCTIONS
1. Disconnect electrical power to the water cooler and shut off water to the unit.
2. Remove the necessary panel(s) to gain access to the hot tank.
3. Drain the hot tank by removing the drain plug from the bottom of the tank.
4. Refer to the drawing of the old style hot tank for the model to be serviced. Cut the water tubes that are connected to the hot tank in the locations
shown.
5. Remove and discard the power cord from the unit by disconnecting from the compressor, cold control, and the hot tank.
6. Remove the hot tank.
7. Using the template for the model being serviced, locate and drill the specified holes in the shelf.
8. Using the two furnished screws (Item 3), mount the new hot tank under the shelf.
9. Route the hot valve tubes to the hot tank and connect using the gray quick connect water fittings. To insert tubing push tube straight into fitting
until it reaches a positive stop, approximateley 3/4. To remove tubing from the fitting, relieve water pressure and push in on gray collar while
pulling on the tubing.
10. Using the supplied power cord, re-wire the unit as shown in the drawing above. Jumper wire (Item 9) routed from switch to hot tank thermostat.
Cut terminals off the fan motor and replace with supplied terminals (Item 10). Route fan motor leads to compressor and attach ribbed lead to the
relay and the smooth lead to the overload. Connect power cord leads to the fan motor terminals (ribbed to ribbed, smooth to smooth).
11. Turn on the water supply and fill the hot tank with water by depressing the hot valve. CHECK FOR LEAKS.
12. Plug the unit in, making sure the compressor and fan run and the hot tank produces hot water.
13. Replace panels.
NOT SHOWN
2222 CAMDEN COURT
OAK BROOK, IL 60523
630.574.3500
PRINTED IN U.S.A.
ITEM NO.
1
2
3
4
5
6
7
8
QTY. DESCRIPTION
1
HOT TANK ASSY
1
POWER CORD
2
SCREW #10 X .50 HHSM
1
TUBE - CU 1/4 X 12.00
2
UNION - 1/4
1
ELBOW - 1/4
1
PLUG - DRAIN
1
TEMPLATE - HOT TANK MTG.
FOR PARTS, CONTACT YOUR LOCAL DISTRIBUTOR OR CALL 1.800.323.0620
SCWT-CB
PART NO.
36129C
36136C
70002C
62177C
70683C
70793C
70606C
92537C
PAGE 292534C (REV. C - 9/02)
WM-CB
PART NO.
36129C
36137C
70002C
62177C
70683C
70793C
70606C
92537C
S-300-CB
PART NO.
36129C
36135C
70002C
62177C
70683C
70793C
70606C
92537C
Loading...