Halsey Taylor HWF172 Water Sentry VII User Manual
GENERAL
Designed to remove cysts, such as
cryptrosporidium and giardia, lead particles
and chlorine. Also reduces odors and
discoloration from incoming water.
Features include Quick-Disconnect, 1⁄4turn
installation. Automatic inlet shut-off valve that
closes when filter is removed. Outer protective
wrap. Spun Polypropylene prefilter mesh to
prevent large, coarse sediment and particles
from entering and clogging filter media.
High-grade filter is made with activated carbon
and patented ATS lead-removal media. Radial
flow-thru design provides more surface area
for untreated water while final filter mesh prevents loose carbon from entering water. Cap
and housing shall be made of rust and corrosion free plastic. Lead and cyst reduction filter
shall be Halsey Taylor Water Sentry VII.
Designed specifically for use with the
following series of Halsey Taylor water coolers:
HAC, HACBL, WM**, SCWT** series, S series
and WMBL. Can also be used on OVLSER,
OVLER, HRF, RC & BFMR units but must be
mounted into the wall behind the unit’s
backplate. CANNOT be used in the HTV, SW,
WC, HBW or the unrefrigerated versions of the
HRF and OVL series.
**For water cooled models contact the factory.
RECOMMENDED USE CONDITIONS
Capacity......................1,500 Gallons (5678 £)
Flow rate .....................0.75gpm (2.8 l/m)
Temperature................40-120°F (4 - 49°C)
Maximum Pressure.....105psi (724 Kpa)
Minimum Pressure......20psi (138 Kpa)
PERFORMANCE TEST CONDITIONS*
Capacity......................1,500 Gallons (5678 £)
Flow rate .....................0.75gpm (2.8 l/m)
Pressure......................60 psi (4.2 Kg/cm2)
Temperature................68-70°F (20-21°C)
*Performance will vary depending on local water conditions.
WATER CONNECTION
•
Water Inlet for 3⁄8" O.D. Tube
•
Water Outlet for 1⁄4" O.D. Tube
STANDARDS
This filter has been tested to the following NSF
International standards: NSF/ANSI Standards
42 Chlorine, Particulate, and Taste and Odor.
NSF/ANSI Standard 53 for Reduction of Lead
and Cyst.
KIT CONSISTS OF:
■ Filter
■ Filter head
■ Mounting bracket
■ 1/4" polytubing, connectors and screws
■ Installation instructions
■ Performance Data Sheet
Shipping Weight: 4 lbs.
55897C REPLACEMENT FILTER
Replacement filter for Water Sentry VII.
Replacement instructions included. Filter
should be replaced every 1,500 gallons (5678
liters) or approximately one (1) year after
installation. Use part # 55897C when ordering
replacement filter.
98262C FILTER MONITOR
Optional accessory monitors the number of
gallons used for determining when to change
filter. When a filter change is due, the monitor
will beep when water is flowing. Monitor
operates on 2 AA alkaline batteries (not
included). Installation instructions included.
NOTE: Continued product improvement makes
specifications subject to change without
notice. See Halsey Taylor website for most
current spec sheet.
E12 / 11-2007
MODEL HWF172 Water Sentry VII™
Reduction Filter
Cyst and Lead
HALSEY TAYLOR, DIV. OF ELKAY MFG., 2222 CAMDEN COURT, OAK BROOK, ILLINOIS 60523
halseytaylor.com
HWF172
Filter Monitor
98262C
Replacement Filter
55897C
JOB NAME:
ENGINEER/CONTRACTOR NAME:
APPROVAL:
DATE:
Printed in the U.S.A.
HWF172 Water Sentry VII™
Cyst and Lead
Reduction Filter
(CONTINUED)
INSTALLATION INSTRUCTIONS
The filter must be installed in compliance
with all state and local laws and regulations
governing the installation and use of this
product.
Disconnect electrical power and close water
supply valve before proceeding.
The filter must be installed on the water inlet line.
Flow indicator (arrow) on filter should point in
the same direction as the water flow.
After installing new filter, open water supply
valve and check for leaks. Flush system
sufficiently (approximately 3 minutes) to
effectively remove small residue of carbon
fines.
NOTE: A water shutoff valve should be
installed on the incoming water line to aid in
future servicing of filter.
CAUTION
•
Filter is designed to reduce lead from
incoming water to levels below EPA
requirements. Do not use with water that
is microbiologically unsafe or with water
of unknown quality without adequate
disinfection before or after the system.
•
Use on water inlet line only. Do not allow
installed filter to freeze. Do not attached hot
water line to filter.
•
Filter should be replaced every 1,500
gallons (5678 liters) or approximately one (1)
year after installation.
FRONT VIEW
WARRANTY
The Halsey Taylor Water Sentry®VII is warranted to be free from defects in material and workmanship for a period of one year
from the date of installation. Warranty is limited to repair or replacement of defective component.
Loading...