Halsey Taylor HRFE-FR Installation Manual

HRFS - FR HRFE-FR

Halsey Taylor Owners Manual

HRFS - FR HRFE - FR

Freeze Resistant Fount ains

HRFS - FR

HRFE - FR

Installer
T o assure you install this model easily and correctly , PLEASE READ THESE SIMPLE
INSTRUCTIONS BEFORE ST ARTING THE INST ALLA TION. CHECK YOUR INST ALLA­TION FOR COMPLIANCE WITH PLUMBING , ELECTRICAL AND OTHER APPLICABLE
CODES. After installation, leave these instructions inside the fountain for future reference.
This Freeze Resistant Fountain is shipped in two separate cartons. The second carton(s)
contains the Freeze Resistant Package(s) HTFRB1 that are installed on an interior
heated wall. The interior space must maintain a minimum temperature of 50° F (10° C).
Refer to the Freeze Resistant Package for the rough-in dimensions for installation.

IMPORTANT

ALL SERVICE TO BE PERFORMED BY AN AUTHORIZED SERVICE PERSON

IMPORTANT! INSTALLER PLEASE NOTE.

THE GROUNDING OF ELECTRICAL EQUIPMENT SUCH AS TELEPHONE, COMPUTERS, ETC. TO
WA TER LINES IS A COMMON PROCEDURE. THIS GROUNDING MA Y BE IN THE BUILDING OR MA Y
OCCUR A WA Y FROM THE BUILDING . THIS GROUNDING CAN CAUSE ELECTRICAL FEEDBACK
INTO A FOUNT AIN, CREA TING AN ELECTROLYSIS WHICH CAUSES A METALLIC T ASTE OR AN
INCREASE IN THE METAL CONTENT OF THE WATER. THIS CONDITION IS A VOIDABLE BY USING
THE PROPER MA TERIALS AS INDICA TED. ANY DRAIN FITTINGS PROVIDED BY THE INST ALLER
SHOULD BE MADE OF PLASTIC TO ELECTRICALL Y ISOLA TE THE FOUNT AIN FROM THE BUILDING
PLUMBING SYSTEM.

PAGE 1 97798C (Rev. G - 8/07)

HRFS - FR HRFE-FR

HRFS - FR/HRFE - FR

MOUNTING BOLT AND ACCESS HOLE LAYOUT

FIG . 1

LEGEND

A = MOUNTING BOL T LOCA TIONS

(4) (3/8" DIA. NOT PROVIDED)

B = 7/8" DIA. (22mm) HOLE FOR

WATER SUPPLY TUBE

C = 7/8" DIA. (22mm) HOLE FOR

OPERA TING CABLE

D = 1-3/4" (44mm) HOLE FOR

WASTE LINE

PAGE 297798C (Rev. G - 8/07)