Halsey Taylor HACFS-L-R ADA User Manual

This water cooler is certified to

NSF/ANSI 61.

GENERAL

Self-contained, electric refrigerated wall-mounted
water cooler easily accessible to physically
challenged individuals. When properly installed,
unit meets state and federal requirements for
both children or adults as defined by the
Americans with Disabilities Act. Unit is certified
to NSF/ANSI 61, and meets requirements of the
Safe Drinking Water Act. Unit provides 50° F
water at 80° F inlet water and 90° F ambient.

CABINET

Stainless steel panels resist wear and corrosion.
Durable satin finish helps hide water spots and
fingerprints.

COOLER TOP

Non-corrosive stainless steel cooler top, no.
300 series with satin finish resists stains and
corrosion and is easy to maintain. Anti-splash
ridge reduces splatter. Contoured to insure
proper drainage.

BUBBLER

Exclusive one-piece, chrome-plated two­stream mound-building bubbler with
non-removable anti-squirt feature and integral
hood insures a satisfying drink of water.

PUSH BAR ACTUATION MECHANISM

Self-closing light-touch push bars on front and
sides with raised letters for the visually
impaired.

AUTOMATIC STREAM HEIGHT REGULATOR

Self-closing assembly is located inside unit to
prevent tampering. Unit resists corrosion and
liming. A constant stream height is automatically
maintained under line pressures that vary from
20 to 105 psi.

INLET STRAINER

Easily cleaned in-line strainer screen traps
particles of 140 microns or larger before they
enter the waterway.

TEMPERATURE CONTROL

Positive sensing thermostat for controlling
temperature of storage tank water. Factory set
at 50° F Adjustable ± 5° F.

STORAGE TANK

Non-pressurized stainless steel
evaporator/storage tank for long life.
Waterways are certified to NSF/ANSI 61,
far exceeding the requirements of the
Safe Drinking Water Act.

REFRIGERATION SYSTEM

Hermetically sealed, positive start compressor
with lifetime lubrication and built-in overload
protection, efficient capillary sizing, large
capacity dryer-strainer, and self-lubricated fan
cools copper/aluminum condenser. System
uses R134A refrigerant. Protected by Halsey
Taylor’s Limited 5 Year Warranty.

VENTILATION

Insure proper ventilation by maintaining
6" (152mm) minimum clearance from
cabinet louvers to wall.

SUGGESTED SPECIFICATIONS

Shall deliver 8.0 GPH of 50° F water at 90° F
ambient and 80° F inlet water. Shall have
stainless steel basin with removable drain
strainer. Bubbler shall be two-stream, mound
building type. Separate valve and automatic
stream regulator shall be mounted within
cabinet. Refrigeration system shall employ high
efficiency, positive start compressor using
R134A, non-pressurized tank with totally
encapsulated insulation and be controlled by
positive sensing thermostat. Shall have front
and side push-bar water controls with raised
lettering for the visually impaired. Cooler shall
comply with ANSI 117:1 and ADA for visual
and motion disabilities. The manufacturer shall
certify the unit to meet the requirements of
NSF/ANSI 61, and the Safe Drinking Water Act.
Unit complies with ARI Standard 1010.

NOTE: Continued product improvement
makes specifications subject to change
without notice. See Halsey Taylor website
for most current spec sheet.

Standard Finish Is Stainless Steel

Optional Finish

■■

Platinum Vinyl

Optional Accessories (extra cost)

■■

Glass Filler Kit

■■

Water Filter

■■

Easy-Flex™Bubbler

HALSEY TAYLOR, 2222 CAMDEN COURT, OAK BROOK, ILLINOIS 60523

A12 / 8-2007

MODEL:

■■

HAC8FS-Q ADA

■■

HACFS-L/R ADA

Barrier-Free Cooler

halseytaylor.com

HAC-Q BARRIER-FREE SERIES

Model GPH Capacity Base F.L. Shipping Rated
No. Cooled to 50° F* Rate Amps Weight Watt

Ambient Air Temp

Cap. lb. Usage

70°F 80°F 90°F†100°F

HAC8FS-Q ADA 9.7 8.8 8.0 7.2 8.0 4.0 67 370

* With projector service and tap water at 80° F

†

UL listed and complies with ARI Standard 1010

Trap and service stop not included

JOB NAME:

ENGINEER/CONTRACTOR NAME:

APPROVAL:

DATE:

Printed in the U.S.A.

Barrier-Free Cooler

(CONTINUED)

MOUNTING HEIGHT

Mounting height recommended 28

1

/

2" from

basin to floor. May be mounted at any desired
height. Check local codes.

MOUNTING INSTRUCTIONS

Mount trap and install service stop to building
supply line. Anchor hanger bracket securely to
wall on all sides. To insure proper engaging of
waste line into trap, centerline of trap must be

6

1

/

4" from wall face. Remove slip nut and gasket

from trap and install on waste line tube. Hang
cooler on bracket and engage waste line tube
into trap inlet. Centerline height of waste outlet
will vary from floor line depending on mounting
height. Install

3

/

8 supply tube to in-line strainer.

Secure bottom of cooler to wall using holes
provided.

Trap and service stop not included.

OPERATING PRESSURES:

Supply water - 105 psi maximum

ELECTRICAL

Furnished with plug-in, 3-wire grounding type
service cord. Standard 120 volt, 60 Hz, single
phase. Install 120-volt receptacle, rated at
15-amp minimum, to receive 3-wire parallel
blade grounding type male plug.

FINISHED FLOOR

*

HANGER BRACKET

E

F

RIM HEIGHT

ORIFICE HEIGHT

5/16" (8mm) DIA. (5 HOLES)

A

D

B

E

C

12 5/16"
313mm

1 3/8"
35mm

1 3/8"
35mm

5 3/4"
146mm

5 3/4"
146mm

L

C

27"
686mm

31 7/8"
810mm

33"
838mm

18 5/8"
473mm

2 9/16"
65mm

13 7/8"
352mm

18 3/8"
467mm

21 3/8"
543mm

25"
635mm

31"
787mm

2 1/2"
64mm

3 1/2"
89mm

4 1/2"
114mm

2 7/16"
63mm

5"
127mm

10"
254mm

11/16"
18mm

2 9/16"
65mm

7 1/4"
185mm

6 1/4"
159mm

8"
203mm

1 1/2"
38mm

4 9/16"
116mm

6 3/4"
172mm

A. RECOMMENDED WATER SUPPLY LOCATION. 3/8" O.D. UNPLATED COPPER TUBE CONNECT STUB

1-1/2" (38 mm) OUT FROM WALL SHUT OFF VALVE NOT FURNISHED.
B. RECOMMENDED LOCATION FOR WASTE OUTLET 1-1/4" O.D. DRAIN
C. 1-1/4" TRAP NOT FURNISHED
D. ELECTRICAL SUPPLY (3) WIRE RECESSED BOX
E. INSURE PROPER VENTILATION BY MAINTAINING 6" (152 mm) MIN. CLEARANCE FROM CABINET LOUVERS TO WALL
F. 7/16" BOLT HOLES FOR FASTENING UNIT TO WALL

FRONT VIEW SIDE VIEW

* Adult ADA requirement. 24" (609mm) for Child ADA.

Adjust other measurements accordingly.

HAC8FS-Q ADA,
HACFS-L/R ADA