Halsey Taylor HAC-4F Installation Manual

Halsey Taylor Instruction Manual

Glass Filler Plumbing Kit

Model: 73-42485-51-550

HAC-4F HAC-8F

HAC-4FS HAC-FS

WARNING

To avoid the risk of electrical shock, personal injury, or death, disconnect power and water
supplies before installing this plumbing kit.

CAUTION

To avoid property damage, personal injury, and voiding your warranty:

* have an authorized person install your plumbing kit
* make sure you read, understand, and follow the attached instructions
* wear protection to protect yourself from sharp edges
* wear safety goggles to protect your eyes from water under pressure and other

projectiles

PARTS LIST

Refer to the parts list to make sure you received all plumbing kit parts. If any parts are
missing, contact your Halsey Taylor dealer.

PARTS LIST

ITEM NO.

1

2

3

4

5

6

7

PART NO.

100322740560

50090C

50279C

60119C

62296C

70682C

70683C

GASKET-BLACK (QTY OF 4)

INSULATION-ARMAFLEX

TAPE-ARMAFLEX INSULATING

TUBE-CU 1/4 X 5.00"

ASSY-BUBBLER TUBE (QTY OF 2)

FITTING-TEE 1/4

FITTING-UNION 1/4

DESCRIPTION

REQUIRED TOOLS

You will need the following tools to install your plumbing kit:

- flat blade screwdriver

- adjustable wrench

- tubing cutter

- phillips screwdriver

- 5/16" nut driver or socket

92874C (Rev. A)

REMOVE THE FRONT PANEL AND BASIN

1. Disconnect the electric power and shut off the cold water supply. Press the push bar to relieve any residual
water pressure.

2. Remove the four front panel screws and remove the front panel.

3. Carefully remove the strainer by using needle nose pliers.

4. Using needle nose pliers, turn the drain plug counterclockwise and remove the plug and gasket. Save the
gasket - it will be used again when unit is re-assembled.

5. Remove bubbler by turning counterclockwise. Discard gasket.

6. Remove the eight basin mounting screws and remove the basin.

92874C (Rev. A)

PAGE 2