GBVAHC*U
HALSEY TAYLOR OWNERS MANUAL
USES HFC-134A REFRIGERANT
GENERAL INSTRUCTIONS FOR BOTTLED DISPENSERS
INSTALLATION
1. Locate water cooler in a well ventilated space where temperature is always above freezing.
2. Insure proper ventilation by maintaining a minimum clearance of 2 (51 mm) on sides and rear of cooler.
3. Make sure cooler is on a level surface.
4. Locate cooler near a three-prong grounding type receptacle. DO NOT USE EXTENSION CORDS.
5. To prevent algae from growing, do not located cooler near direct sunlight.
START UP
1. Install drain receptacle and grid below faucet.
2. Thoroughly clean the reservoir and baffle(using a mild dishwashing detergent). Baffle must be in place for proper
cooling operation.
3. Connect cooler to electrical supply. CAUTION: HOT TANK MUST BE FILLED WITH WATER BEFORE UNIT IS CON
NECTED TO ELECTRICAL SOURCE, IN ORDER TO PREVENT POSSIBLE DAMAGE TO THE HOT TANK.
4. HOT TANK SERVICE SWITCH: For models equipped with a rocker switch on the rear of the cooler, this switch must be
in the | position (ON) for the hot tank operation.
5. Invert the water bottle on top of unit. CAUTION: Avoid filling the water tank above the level normally maintained by the
inverted bottle.
6. Hold faucet open until air bubbles rise in water bottle. On hot models, depress hot valve until water flow is continuous
and clear.
CLEANING
1. Cabinet top, side panels, front panel, grid and drain receptacle can be cleaned with any NON-abrasive household
cleaner which does NOT contain solvents. To prevent damage to plastic panels, avoid cleaning aids such as steel
wool, scouring pads, etc. NOTE: ALWAYS REMOVE POWER SUPPLY CORD FROM THE WALL RECEPTACLE
BEFORE CLEANING.
MAINTENANCE
1. COLD THERMOSTAT: The thermostat is set to deliver water at approximately 50°F (10°C.). For colder water, adjust the
screw on the thermostat clockwise. The thermostat is located at the rear of the cooler.
2. HOT THERMOSTAT: The thermostat is factory set to deliver water at approximately 185°F(85°C.) and is NOT adjust
able.
CAUTION: HOT TANK MUST BE FILLED WITH WATER BEFORE CONNECTING TO THE ELECTRICAL SOURCE.
3. LUBRICATION: None required.
4. CONDENSER: To ensure optimum cooler performance, condenser must be maintained free of dust and lint. Con
denser must be regularly inspected and cleaned with a brush.
5. DRAIN RECEPTACLE: The drain receptacle should be emptied and cleaned regularly. To remove, lift receptacle
straight up and then away from the cabinet.
6. STORAGE or RETURN SHIPMENT: If the cooler is removed from service, the water must be completely drained from
the system.
7. REPLACING WATER BOTTLE: Open faucet until air bubbles rise in bottle after each replacement, this will ensure
correct water level for proper operation.
97825C (REV. D - 7/03)PAGE 1
ITEM NO.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
*23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
PART NO.
56153C
66670C
51952C
36098C
38417001
51861C
B52211C
51868C
56149C
56151C
B52213C
B52212C
B52217C
71019C
36157C
28297C
28298C
36101C
62290C
70418C
28300C
50144C
36115C
60119C
36097C
62289C
66688C
111411443890
28301C
28302C
35826C
56148C
75626C
28299C
56147C
36176C
31797C
36179C
GBVAHC*U
ITEMIZED PARTS LIST
DESCRIPTION
BAFFLE
ASSY - EVAP. MIDPAN(BOTTLE)
CAP - BULBWELL TUBE
COLD CONTROL
SCREW-#8 -18 x .37" HHSM
TOP - CABINET (WHITE)(BOTTLE)
ALCOVE (WHITE)
ALCOVE INSERT (WHITE)
FAUCET-WHITE W/BLUE HANDLE (COLD)
FAUCET-WHITE W/RED HANDLE (HOT)-CHILD RESISTANT
RECEPTACLE - DRAIN (WHITE)
PANEL - LOWER FRONT (WHITE)
PANEL - PLASTIC SIDE (WHITE)
SCREW-#8-18 X .50" LG HEX HEAD
HOT TANK ASSEMBLY
STRUT-FRONT
STRUT-REAR
SWITCH - ROCKER
HEAT EXCHANGER
WASHER - PLAIN
BASEPLATE
GROMMET
COMPRESSOR SERVICE PACK
TUBE - CU 1/4" DIA X 5.00" LG
CORD-POWER
DRIER
CONDENSER
SCREW-#8 - 36 X .38 TRI-LOBED
HANDLE(BOTTLE0
STRIP-MOUNTING
INLET-POWER
WASHER-VALVE/FAUCET
HAIR PIN-COTTER
BRACKET-SIDE PANEL
CAP-BAFFLE
OVERLOAD
RELAY COVER
RELAY
2222 CAMDEN COURT
OAK BROOK, IL 60523
*INCLUDES RELAY & OVERLOAD. IF UNDER WARRANTY, REPLACE WITH SAME COMPRESSOR
USED IN ORIGINAL ASSEMBLY.
NOTE: All correspondence pertaining to any of the above water coolers or orders for repair parts
MUST include Model No. and Serial No. of cooler, name and part number of replacement part.
WIRING DIAGRAM
COLD
CONTROL
HOT
TANK
BLACK
COMPRESSOR
FOR PARTS, CONTACT GRAINGER PARTS AT 1.800.323.0620 OR FACTORY DIRECT AT:
DBL BLACK
BLACK
DBL WHITE
DBL WHITE
ROCKER
SWITCH
DBL BLACK
POWER
INLET
DBL
GREEN(GRD)
Phone 630.574.3500
Fax: 630.574.3503
PRINTED IN U.S.A.
97825C (REV. D - 7/03)PAGE 3
GBVAHC*U
LIMITED WARRANTY
BOTTLE WATER DISPENSER
TERMS AND CONDITIONS - This warranty is limited to a dispenser installed in non-restricted locations, such as residences or offices. The
labor allowances provided, cover normal installation sites, (not built-in applications). Labor allowances are also limited to normal working
hours, and repair schedules.
This limited warranty does not offer coverage for components that are not factory installed, such as dealer installed accessories not originally
sold by manufacturer.
If paint or other appearance imperfections are noted at time of installation, the owner must advise the installer or the supplier without delay.
INSTALLATION AND OPERATION - The foregoing Limited Warranty applies only when the dispenser is installed and operated in accordance
with the Manufacturers written instructions included with each unit. It does not apply to dispensers which on examination by the Manufacturer,
or his agent, are found to have been subjected to accident, modifications, abuse, misuse, misapplications, corrosive type atmospheres, or
abnormal use.
FIRST YEAR - The Manufacturer warrants the complete water dispenser including compressor, hermetically sealed refrigeration system,
water system, faucets, and electrical components to be free from defects in material and workmanship under normal use for (1) year from date
of installation or eighteen (18) months from date of shipment from Elkays factory, whichever occurs first.
SECOND AND THIRD YEARS - HOT TANK - Covers replacement of tank assembly with labor allowance when defect is not caused by
calcium deposits, or other supply water problems not caused by workmanship or material. PLASTIC WRAPPER - Limited to the replacement of the wrapper, when defect is due to workmanship or material, excludes labor.
SECOND THROUGH FIFTH YEARS - Coverage is limited to repair of defective component or replacement of complete dispenser at Manufacturers
option.
REFRIGERATION SYSTEM - Includes repair or replacement of the following listed parts, including a labor allowance: compressor,
evaporator, condenser, connecting refrigerant lines, and drier.
WATER SYSTEM- water containing component parts must be permanently attached to a refrigeration component part. Includes labor
allowance. Faucets, interconnecting water lines, and other water connections are not covered by this portion of the warranty.
ELECTRICAL SYSTEM - Limited to a replacement of defective components caused by workmanship or material for the following
component parts: cold control, hot control/fuse assembly, compressor start relay, compressor overload.
OWNERS OBLIGATIONS - Owner to provide proof of installation date when repair is required. The owner has the obligation and responsibility
to diagnose and/or make minor adjustments and to reimburse the authorized service center or the Manufacturer for any other repair not
covered by the terms of this Limited Warranty. The owner also has the obligation and responsibility to return the complete unit to the closest
authorized service center or to the factory repair department if the compressor, refrigeration or water system is found to be defective during
the warranty period.
MANUFACTURERS OBLIGATIONS - The manufacturers obligation under this Limited Warranty is limited to providing labor and parts to repair
or replace any part of the water dispenser which is expressly covered by this Limited Warranty as stated above at one of its authorized
service centers or at its factory repair department. The Manufacturers obligation also includes costs of outbound freight (but not express
freight) of the part or parts from an authorized service center or the factory repair department, but only if the Manufacturer determines that the
part or parts, and the purported defect or defects, are covered by this Limited Warranty.
PERSONS ENTITLED TO BENEFIT OF WARRANTY - This Limited Warranty is applicable only to (i) purchasers who purchase the water
dispenser for resale in the ordinary course of business, and (ii) the first person who purchases the water dispenser other than for resale.
THIS LIMITED WARRANTY IS IN LIEU OF ALL OTHER EXPRESS WARRANTIES. ALL IMPLIED WARRANTIES, ARISING BY LAW OR OTHERWISE,
INCLUDING WITHOUT LIMITATION, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE
LIMITED TO THE SAME PERIOD OF TIME AS THIS LIMITED WARRANTY. Some states of the United States do not allow limitations on how long
an implied warranty lasts, so the above limitation may not apply.
THIS WARRANTY MAY NOT BE ALTERED, VARIED, OR EXTENDED, EXCEPT BY A WRITTEN INSTRUMENT EXECUTED BY THE MANUFACTURER.
THE REMEDY OF REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS LIMITED WARRANTY IS EXCLUSIVE. IN NO EVENT SHALL THE
MANUFACTURER BE LIABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES TO ANY PERSON, WHETHER OR NOT OCCASIONED BY
NEGLIGENCE OF THE MANUFACTURER, INCLUDING WITHOUT LIMITATION DAMAGES FOR LOSS OF USE, COSTS OF SUBSTITUTION, PROPERTY DAMAGE, OR OTHER MONETARY LOSS. Some states of the United States do not allow the exclusion of limitation of incidental or
consequential damages, so the above limitation or exclusion may not apply.
This Limited Warranty gives specific legal rights and in some states of the United States there may also be other rights which vary from state
to state.
Any questions regarding this Limited Warranty or performance of the Manufacturers obligations under this Limited Warranty should be
addressed to Elkay Manufacturing Company.
EXCEPT AS OTHERWISE EXPRESSLY PROVIDED ABOVE, THE MANUFACTURER MAKES NO WARRANTIES, EXPRESS OR IMPLIED, ARISING BY
LAW OR OTHERWISE, INCLUDING WITHOUT LIMITATION THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
PURPOSE, TO ANY PERSON.
DATE OF INSTALLATION______________________________________
SERIAL NUMBER_____________________________________________ OAK BROOK, ILLINOIS 60523
(To Be Filled In By Installer) Form to be left with the owner by the installer.
2222 CAMDEN COURT
PAGE 497825C (REV. D - 7/03)