GBMAKV*C GBMAHV*C
HALSEY TAYLOR OWNERS MANUAL
USES HFC-134A REFRIGERANT
INSTALLATION
1. Locate water cooler in a well ventilated space where temperature is always
above freezing.
2. Insure proper ventilation by maintaining a minimum clearance of 2(51mm)
on sides and rear of cooler.
3. Make sure cooler is on a level surface.
START UP
1. Install drip tray below faucet.
2. Thoroughly clean the cooling tank and baffle. Baffle must be in place for
proper cooling operation.
3. Remove the cap from bottle and invert the bottle on the top of the unit.
CAUTION: Avoid filling the water tank above the level normally maintained
by inverted bottle.
FIG. 1
4. Hold faucet handle down until air bubbles rise in water bottle. On hot
models, depress hot faucet handle until water flow is continuous and clear.
Connect cooler to electrical supply.
CAUTION: HOT TANK MUST BE FILLED WITH WATER BEFORE
CONNECTING TO ELECTRICAL SOURCE.
CLEANING
ALL PLASTIC PARTS ARE DISHWASHER SAFE.
Bottle ring, drip tray and shelf can be cleaned with any NON-abrasive household cleaner. To prevent damage to plastic parts, avoid abrasive cleaning aids
such as steel wool, etc.
MAINTENANCE
TEMPERATURE CONTROL (Cold Control): The thermostat is set to deliver
water at approximately 45° F. (7° C.). For colder water, adjust the screw on the
thermostat clockwise. The thermostat is located at the rear of cooler.
TEMPERATURE CONTROL (Hot Water): The thermostat is factory set to
deliver water at approximately 180° F. (82° C.) and is not adjustable.
CAUTION: HEATER TANK MUST BE FILLED WITH WATER BEFORE CONNECTING TO THE ELECTRICAL SOURCE.
LUBRICATION: None required.
CONDENSER: To ensure optimum cooler performance, condenser must be
maintained free of dust and lint. Condenser must be regularly inspected and
cleaned with a brush.
DRIP TRAY: The drip tray should be emptied and cleaned regularly. To remove
pull drip tray straight forward from the cabinet.
REPLACING WATER BOTTLE: Depress faucet handle(s) until air bubbles rise
in bottle after each replacement, this will ensure correct water level for proper
operation.
STORAGE or RETURN SHIPMENT: If the cooler is removed from service, the
water must be completely drained from the system.
97790C (REV. C - 7/03)PAGE 1
ITEM NO. GBMAKV
56142C
1
56144C
2
56148C
3
51527C
4
51526C
5
-
52267C
6
71019C
7
56153C
8
66667C
9
10
11
12
13
14*
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
NS
-
23285C
66675C
36115C
52442C
50196C
70420C
70951C
36097C
62289C
36098C
66665C
36113C
28293C
36176C
31797C
55903C
36179C
111411443890
GBMAKV*C GBMAHV*C
ITEMIZED PARTS LIST
GBMAHV
56142C
56144C
56148C
51527C
51998C
52267C
71019C
56153C
66666C
56147C
36156C
23285C
66675C
36115C
52442C
50196C
70420C
70951C
36097C
62289C
36098C
66665C
36113C
71014C
36176C
31797C
55903C
36179C
111411443890
BOTTLE RING
SHELL-CABINET (WHITE)
WASHER-FAUCET
FAUCET-WHITE W/BLUE HANDLE (COLD)
FAUCET-WHITE W/WHITE HANDLE (COOK)
FAUCET-WHITE W/RED HANDLE (HOT)-CHILD RESISTANT
DRIPTRAY (GRANITE)
SCREW-#8-18 SPECIAL
BAFFLE
ASSY-EVAP. MIDPAN
CAP-BAFFLE
HOT TANK ASSEMBLY 115V
STRUT
HEAT EXCHANGER
COMPRESSOR SERVICE PACK
BASE
GROMMET
WASHER-PLAIN (SPECIAL)
SCREW-#10-16 x 1.38" LG. HEX. HEAD HI-LOW
CORD-POWER
DRIER
COLD CONTROL
CONDENSER
INLET-POWER
PANEL-RECEPTACLE MOUNTING
SCREW-#10 - 16 X .50 HHHL
OVERLOAD
RELAY COVER
PROTECTOR STRIP
RELAY
SCREW- #8 - 36 X .38 TRI-L0BED
DESCRIPTION
*INCLUDES RELAY & OVERLOAD. IF UNDER WARRANTY, REPLACE WITH SAME COMPRESSOR
USED IN ORIGINAL ASSEMBLY.
NOTE: All correspondence pertaining to any of the above water coolers or orders for repair parts
MUST include Model No. and Serial No. of cooler, name and part number of replacement part.
WIRING DIAGRAM GBMAKV
BLACK
COLD
CONTROL
COMPRESSOR
BLACK
WHITE
POWER
INLET
GREEN(GRD)
WIRING DIAGRAM GBMAHV
COLD
DBL BLACK
CONTROL
HOT
TANK
DBL BLACK
DBL WHITE
BLACK
COMPRESSOR
DBL WHITE
POWER
INLET
DBL
GREEN(GRD)
FOR PARTS, CONTACT GRAINGER PARTS AT 1.800.323.0620 OR FACTORY DIRECT AT:
2222 CAMDEN COURT
OAK BROOK, IL 60523
Phone 630.574.3500
Fax: 630.574.3503
PRINTED IN U.S.A.
97790C (REV. C - 7/03)PAGE 3
GBMAKV*C GBMAHV*C
LIMITED WARRANTY
CLASSIC WATER DISPENSER
TERMS AND CONDITIONS - This warranty is limited to a dispenser installed in non-restricted locations, such as residences or offices. The
labor allowances provided, cover normal installation sites, (not built-in applications). Labor allowances are also limited to normal working
hours, and repair schedules.
This limited warranty does not offer coverage for components that are not factory installed, such as dealer installed accessories not originally
sold by manufacturer.
If paint or other appearance imperfections are noted at time of installation, the owner must advise the installer or the supplier without delay.
INSTALLATION AND OPERATION - The foregoing Limited Warranty applies only when the dispenser is installed and operated in accordance
with the Manufacturers written instructions included with each unit. It does not apply to dispensers which on examination by the Manufacturer,
or his agent, are found to have been subjected to accident, modifications, abuse, misuse, misapplications, corrosive type atmospheres, or
abnormal use.
FIRST YEAR - The Manufacturer warrants the complete water dispenser including compressor, hermetically sealed refrigeration system,
water system, faucets, and electrical components to be free from defects in material and workmanship under normal use for (1) year from date
of installation or eighteen (18) months from date of shipment from Elkays factory, whichever occurs first.
SECOND AND THIRD YEARS - HOT TANK - Covers replacement of tank assembly with labor allowance when defect is not caused by
calcium deposits, or other supply water problems not caused by workmanship or material. PLASTIC WRAPPER - Limited to the replacement of the wrapper, when defect is due to workmanship or material, excludes labor.
SECOND THROUGH FIFTH YEARS - Coverage is limited to repair of defective component or replacement of complete dispenser at Manufacturers
option.
REFRIGERATION SYSTEM - Includes repair or replacement of the following listed parts, including a labor allowance: compressor,
evaporator, condenser, connecting refrigerant lines, and drier.
WATER SYSTEM- water containing component parts must be permanently attached to a refrigeration component part. Includes labor
allowance. Faucets, interconnecting water lines, and other water connections are not covered by this portion of the warranty.
ELECTRICAL SYSTEM - Limited to a replacement of defective components caused by workmanship or material for the following
component parts: cold control, hot control/fuse assembly, compressor start relay, compressor overload.
OWNERS OBLIGATIONS - Owner to provide proof of installation date when repair is required. The owner has the obligation and responsibility
to diagnose and/or make minor adjustments and to reimburse the authorized service center or the Manufacturer for any other repair not
covered by the terms of this Limited Warranty. The owner also has the obligation and responsibility to return the complete unit to the closest
authorized service center or to the factory repair department if the compressor, refrigeration or water system is found to be defective during
the warranty period.
MANUFACTURERS OBLIGATIONS - The manufacturers obligation under this Limited Warranty is limited to providing labor and parts to repair
or replace any part of the water dispenser which is expressly covered by this Limited Warranty as stated above at one of its authorized
service centers or at its factory repair department. The Manufacturers obligation also includes costs of outbound freight (but not express
freight) of the part or parts from an authorized service center or the factory repair department, but only if the Manufacturer determines that the
part or parts, and the purported defect or defects, are covered by this Limited Warranty.
PERSONS ENTITLED TO BENEFIT OF WARRANTY - This Limited Warranty is applicable only to (i) purchasers who purchase the water
dispenser for resale in the ordinary course of business, and (ii) the first person who purchases the water dispenser other than for resale.
THIS LIMITED WARRANTY IS IN LIEU OF ALL OTHER EXPRESS WARRANTIES. ALL IMPLIED WARRANTIES, ARISING BY LAW OR OTHERWISE,
INCLUDING WITHOUT LIMITATION, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE
LIMITED TO THE SAME PERIOD OF TIME AS THIS LIMITED WARRANTY. Some states of the United States do not allow limitations on how long
an implied warranty lasts, so the above limitation may not apply.
THIS WARRANTY MAY NOT BE ALTERED, VARIED, OR EXTENDED, EXCEPT BY A WRITTEN INSTRUMENT EXECUTED BY THE MANUFACTURER.
THE REMEDY OF REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS LIMITED WARRANTY IS EXCLUSIVE. IN NO EVENT SHALL THE
MANUFACTURER BE LIABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES TO ANY PERSON, WHETHER OR NOT OCCASIONED BY
NEGLIGENCE OF THE MANUFACTURER, INCLUDING WITHOUT LIMITATION DAMAGES FOR LOSS OF USE, COSTS OF SUBSTITUTION, PROPERTY DAMAGE, OR OTHER MONETARY LOSS. Some states of the United States do not allow the exclusion of limitation of incidental or
consequential damages, so the above limitation or exclusion may not apply.
This Limited Warranty gives specific legal rights and in some states of the United States there may also be other rights which vary from state
to state.
Any questions regarding this Limited Warranty or performance of the Manufacturers obligations under this Limited Warranty should be
addressed to Elkay Manufacturing Company.
EXCEPT AS OTHERWISE EXPRESSLY PROVIDED ABOVE, THE MANUFACTURER MAKES NO WARRANTIES, EXPRESS OR IMPLIED, ARISING BY
LAW OR OTHERWISE, INCLUDING WITHOUT LIMITATION THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
PURPOSE, TO ANY PERSON.
DATE OF INSTALLATION______________________________________
SERIAL NUMBER_____________________________________________ OAK BROOK, ILLINOIS 60523
(To Be Filled In By Installer) Form to be left with the owner by the installer.
2222 CAMDEN COURT
PAGE 497790C (REV. C - 7/03)