Halsey Taylor 98312C User Manual

GENERAL

The cane touch apron is designed to provide
symmetry along the front of the units. Available
in stainless steel or platinum vinyl finishes. For
use on all Halsey Taylor HAC and HVR Series
bi-level units to assist with compliance to the
protruding objects requirements of ADA
(Americans with Disabilities Act).

Note: Floor to underside measurements of
cane apron equals 27" when mounted correctly.

KIT CONSISTS OF:

■ Cane Apron

■ Screws

■ Installation instructions

Available finishes include:

■ Stainless Steel

■ Platinum Vinyl

Shipping Weight: 3.75 lbs.

TO ORDER:

Use part #98324C for stainless steel
HACFSBL-Q SS or HVRBL ADA models.

Use part #98312C for platinum vinyl
HAC8FSBL-Q model.

NOTE: Continued product improvement makes
specifications subject to change without
notice. See Halsey Taylor website for most
current spec sheet.

HALSEY TAYLOR, 2222 CAMDEN COURT, OAK BROOK, ILLINOIS 60523

E34 / 4-2009

98312C and 98324C Cane Touch Aprons
for HAC and HVR Series

Cane Touch Apron

halseytaylor.com

98324C Cane Apron shown installed on

Halsey Taylor Model HVR8BL ADA

JOB NAME:

ENGINEER/CONTRACTOR NAME:

APPROVAL:

DATE:

Printed in the U.S.A.

98312C and 98324C
Cane Touch Aprons
for HAC and HVR Series

(CONTINUED)

TOOLS REQUIRED

• Phillips Head Screwdriver

• Pinned Torx Head Driver

• Power Drill with 1/8" Drill Bit

• Hammer and Center Punch

INSTALLATION PROCEDURE:

1) Using cane apron as a template use a center
punch to mark hole locations on front of left
and right side panels.

2) Drill 1/8" diameter holes at marked
locations. (Center punch hole locations
before drilling). When drilling the right hand
hole, on refrigerated units, be certain to drill
straight.

CAUTION: Keep the drill bit away from the
refrigeration condenser. If the drill damages
or punctures the condenser refrigeration
tubing, severe and expensive damage to
the refrigeration system will result.

3) Loosen and remove (2) front screws from
underside of cooler/fountain dispenser panels.

4) Install cane touch apron to underside of
cooler/fountain dispenser panels.

5) Reuse fasteners removed in step 3.

6) Attach lower edges of apron to cooler side
panels with screws provided. (Using two
holes drilled in step 2 above)

CANE TOUCH

APRON

STYLE OF COOLER

MAY VARY

UNIT W/O REFRIG.

SHOWN

SCREWS PROVIDED

1/8" DIA. HOLE (2)