Halsey Taylor 98232C User Manual
GENERAL
The cane touch apron is an optional accessory
designed to satisfy customer preference for
symmetry on HVR bi-level units as the bottoms
of the units are brought into line with each
other. Available in stainless steel only. For use
on all Halsey Taylor HVR Series units. When
installed properly, all HVR units meet child ADA
requirements without the cane apron. Overall
dimension: 18" W x 6
1
/2" H x 8 3/4" D.
Note: Floor to underside measurements of
cane apron equals 24" when mounted correctly.
KIT CONSISTS OF:
■ Cane Apron
■ Screws
■ Installation instructions
Available in stainless steel finish only
Shipping Weight: 3.75 lbs.
Use part # 98232C when ordering.
Important: For use with units produced prior
to July 2007.
NOTE: Continued product improvement makes
specifications subject to change without
notice. See Halsey Taylor website for most
current spec sheet.
HALSEY TAYLOR, 2222 CAMDEN COURT, OAK BROOK, ILLINOIS 60523
E23 / 3-2009
98232C Cane Touch Apron
for HVR Series
Cane Touch Apron
halseytaylor.com
98232C Cane Apron shown installed on
Halsey Taylor Model HVR8BL ADA
JOB NAME:
ENGINEER/CONTRACTOR NAME:
APPROVAL:
DATE:
Printed in the U.S.A.
98232C Cane Touch Apron
for HVR Series
(CONTINUED)
TOOLS REQUIRED
• Phillips Head Screwdriver
• Torx Head Driver
• Power Drill with 1/8" Drill Bit
• Hammer and Center Punch
INSTALLATION PROCEDURE:
1) Using template provided, mark hole locations
on front of left and right side panels.
TOP - Align with corner between side
panel and dispenser panel. (See Item - A)
OUTSIDE EDGE - Align with outside edge
of side panels. (See Item - B)
2) Drill 1/8" diameter holes at marked
locations. (Center punch hole locations
before drilling) When drilling the right hand
hole, on refrigerated units, be certain to drill
straight.
CAUTION: Keep the drill bit away from the
refrigeration condenser. If the drill damages
or punctures the condenser refrigeration
tubing, severe and expensive damage to the
refrigeration system will result.
3) Loosen and remove screws from underside
of cooler/fountain dispenser panels.
4) Install cane touch apron to underside of
cooler/fountain dispenser panels.
5) Reuse fasteners removed in step 3.
6) Attach lower edges of apron to cooler side
panels with screws provided. (Using two
holes drilled in step 2 above)
Loading...