Halsey Taylor 98030C Service Manual
Universal Vandal Resistant Kit 98030C
Service Manual
This kit contains a sufficient quantity of tamper-resistant screws to modify your water cooler.
Kit consists of:
ITEM NO.
PAGE NO.
1
2
3
4
TABLE OF CONTENTS
HCRF, WC8A, HAC,
HTE & HRFE Models
SCWT, WM8A & SW8A Models
OVL-E Model & Std. to VR Bubbler
replacement instructions for all
HALSEY TAYLOR product
HTV model
1
2
3
4
5
6
7
8
HCRF, HTE & HRFE model modification instructions:
1. Remove bottom cover screws one at a time and replace
with a tamper-resistant screw of the same size and length.
Special drive bits are provided for the tamper resistant
screws.
CAUTION: DO NOT REMOVE ALL EXTERIOR SCREWS BEFORE
REPLACING THEM WITH TAMPER-RESISTANT SCREWS.
HAC & WC8A model modification instructions:
QTY.
1
1
18
10
1
1
2
2
PARTS LIST
PART NO.
75520C
75523C
75570C
75661C
15009C
45392C
75564C
75566C
Fig. A
HCRF
Shown
DESCRIPTION
Bit - Pinned Torx T-25
Bit - Pinned Torx T-20
Screw - #10 X .50” Pinned Torx
Screw - #8 X .50” Pinned Torx
Bubbler Nipple
VR Bubbler
Locking Washer
Screw - #10 X 1” Pinned Torx
4
1. Remove exterior screws one at a time and replace
with a tamper-resistant screw of the same size and length.
Special drive bits are provided for the tamper resistant
screws.
4
3
4
3*
3*
3
4
3*
3
This fastener should not be replaced
3*
Fig. C
WC8A
Fig. B
HAC
4
When disassembling the hinge pivot points on this unit, replace the
*
vandal resistant screw immediately. Be certain that the pivot
block remains fully seated in place when replacing the vandal
PRINTED IN U.S.A.
FOR PARTS CONTACT YOUR LOCAL DISTRIBUTOR OR VISIT OUR WEBSITE - WWW.HALSEYTAYLOR.COM
3
resistant screw.
3*
4
4
1
98031C (REV. B - 5/09)
WM8A & SW8A model modification instructions:
1. Remove exterior screws one at a time and replace
with a tamper-resistant screw of the same size and length.
Special drive bits are provided for the tamper resistant
screws.
3
Fig. D
WM8A
Shown
3
SCWT model modification instructions:
1. Remove exterior screws one at a time and
replace with a tamper-resistant screw of
the same size and length. Special drive bits
are provided for the tamper resistant screws.
Fig. E
SCWT
3
3
FOR PARTS CONTACT YOUR LOCAL DISTRIBUTOR OR VISIT OUR WEBSITE - WWW.HALSEYTAYLOR.COM
98031C (REV. B - 5/09)
3
2
Loading...