Halsey Taylor 6028 Installation Manual

6028 FOUNTAIN

Halsey Taylor Installation Manual

Model 6028

Countertop Fountains

Installer

To assure you install this model easily and correctly,
PLEASE READ THESE SIMPLE INSTRUCTIONS BEFORE STARTING THE
INSTALLATION. CHECK YOUR INSTALLATION FOR COMPLIANCE WITH
PLUMBING, ELECTRICAL AND OTHER APPLICABLE CODES. After installation, leave these
instructions inside the fountain for future reference.

IMPORTANT

ALL SERVICE TO BE PERFORMED BY AN AUTHORIZED SERVICE PERSON

1. Water supply 3/8" O.D. unplated copper tube. Waste 1-1/2" O.D. tube. Contractor to supply waste
trap and service stop valve in accordance with local code.

2. Connecting lines to be made of unplated copper and should be thoroughly flushed to remove all
foreign matter before being connected to fountain. This fountain is manufactured in such a manner
that it does not in any way cause taste, odor, color, or sediment problems.

3. Connect the 3/8" O.D. unplated copper water line from the fountain to the service stop valve (see
figs.3 and 4). DO NOT SOLDER TUBES INSERTED INTO THE STRAINER AS DAMAGE TO

THE O-RINGS MAY RESULT.

4. These products are designed to operate on 20 psig to 105 psig supply line pressure. If inlet pressure
is above 105 psig, a pressure regulator must be installed in the supply line. Any damage caused by
reason of connecting this product to supply line pressures lower than 20 psig or higher than 105 psig
is not covered by warranty.

PAGE 1

97274C (Rev. C - 7/04)

6028 FOUNTAIN

STREAM HEIGHT ADJUSTMENT: Stream height is factory set at 35 PSI.
If supply pressure varies greatly from this, remove items 16 & 17
(see Fig.2) and adjust screw on item 24. Clockwise adjustment
will raise stream and counter-clockwise adjustment will lower
stream. For best adjustment, stream should hit basin approx.
6-1/2" from bubbler.

FIG. 1

CORRECT STREAM HEIGHT

17 20

2

1516 24

FIG. 2

OPERATION OF QUICK CONNECT FITTINGS

Simply Push In Tube

To Attach

AB C

Tube Is Secured In

Position

Push In Collet To

Release Tube

Pushing Tube In Before

Pulling It Out Helps To

Release Tube.

97274C (Rev. C - 7/04)

1/4" O.D. TUBE
WATER INLET
TO COOLER

3/8" O.D. UNPLATED
COPPER TUBE CONNECT
COLD WATER SUPPLY

NOTE: WATER FLOW

DIRECTION

FIG. 3

FIG. 4

PAGE 2

BUILDING WATER
INLET

SERVICE STOP
(NOT FURNISHED)