Halsey Taylor 5701C Installation Manual

5701*C FOUNTAIN

Halsey Taylor Owners Manual

Wall Mount Fountain

INSTALLER

Halsey Taylor Fountains are among the easiest to install Fountains on the
market today. To assure you install these models easily and correctly,
PLEASE READ THESE SIMPLE INSTRUCTIONS BEFORE STARTING THE
INSTALLATION. CHECK YOUR INSTALLATION FOR COMPLIANCE WITH
PLUMBING, ELECTRICAL, AND OTHER APPLICABLE CODES. After instal­lation, leave these instructions with the Fountain for future reference.

IMPORTANT

ALL SERVICE TO BE PERFORMED BY AN AUTHORIZED SERVICE PERSON

IMPORTANT! INSTALLER PLEASE NOTE.

THE GROUNDING OF ELECTRICAL EQUIPMENT SUCH AS TELEPHONE, COMPUTERS, ETC. TO WATER
LINES IS A COMMON PROCEDURE. THIS GROUNDING MAY BE IN THE BUILDING OR MAY OCCUR AWAY
FROM THE BUILDING. THIS GROUNDING CAN CAUSE ELECTRICAL FEEDBACK INTO A FOUNTAIN, CREATING
AN ELECTROLYSIS WHICH CAUSES A METALLIC TASTE OR AN INCREASE IN THE METAL CONTENT OF THE
WATER. THIS CONDITION IS AVOIDABLE BY USING THE PROPER MATERIALS AS INDICATED. ANY DRAIN
FITTINGS PROVIDED BY THE INSTALLER SHOULD BE MADE OF PLASTIC TO ELECTRICALLY ISOLATE THE
FOUNTAIN FROM THE BUILDING PLUMBING SYSTEM.

1. Water supply 3/8" O.D. unplated copper tube. Waste 1-1/4" O.D. Contractor to supply waste trap and service
stop valve in accordance with local code.

2. Connecting lines to be made of unplated copper and should be thoroughly flushed to remove all foreign matter
before being connected to fountain. This fountain is manufactured in such a manner that it does not in any
way cause taste, odor, color, or sediment problems.

3. These products are designed to operate on 20 psig to 105 psig supply line pressure. If inlet pressure is above
105 psig, a pressure regulator must be installed in the supply line. Any damage caused by reason of
connecting this product to supply line pressures lower than 20 psig or higher than 105 psig is not covered by
warranty.

PAGE 1

97593C (2/00)

LEGEND:

A = RECOMMENDED WATER SUPPLY LOCATION,

5701*C FOUNTAIN

3/8 O.D. UNPLATED COPPER TUBE CONNECT.

B = RECOMMENDED LOCATION FOR

WASTE OUTLET, 1-1/4 O.D. DRAIN.

C = 1-1/4 TRAP NOT FURNISHED.

D = MOUNTING HOLES FOR BASIN

HANGER STRAP.

E = MOUNTING HOLES FOR FOUNTAIN

ROUGH-IN DIMENSIONS

FIG. 1

FINISHED FLOOR

PISO ACABADO

PLACHER FINI

97593C (2/00)

PAGE 2