Halsey Taylor 4461 User Manual

GENERAL

Pedestal, Endura II™Steel yard hydrant with textured powder coat ﬁnish and E-Coat immersion for year-round beauty with minimum maintenance. The E-Coat immersion process coats the outside and inside of the hydrant for the ultimate in corrosion protection. Hydrant provides ability to connect garden hoses or ﬁll pails in outdoor applications. Ideal for golf courses, ball parks and swimming pools for irrigation purposes. This hydrant is rated for inlet water pressure of 20-105 psi. Model 4460

is hydrant with non-locking hose bib. Model 4461 includes panel and a door that can be secured with a standard padlock (not

included).

WATER INLET

1/2" O.D. Tubing

SUGGESTED SPECIFICATIONS

Hydrant shall include 10" domed cap with vandal-resistant screws. Model 4460 has access panel with recessed hose bib. Model 4461 has access panel with recessed hose bib and a door that can be secured with a standad padlock (not included). Not designed for sub-freezing applications.

Note: Continued product improvement makes speciﬁcations subject to change without notice. See Halsey Taylor website for most current spec sheet.

Standard ﬁnish is Evergreen textured powder-coat Endura II

™

Each 4460/4461 consists of 1 carton of the following:

Hydrant

Service stop not included.

Shipping weight: 4460 101 lbs.

4461 108 lbs.

HALSEY TAYLOR, 2222 CAMDEN COURT, OAK BROOK, ILLINOIS 60523

D14 / 8-2007

MODEL: ■■ 4460 ■■ 4461

Yard Hydrant

Endura II™Tubular

halseytaylor.com

4460

4461

JOB NAME:

ENGINEER/CONTRACTOR NAME:

APPROVAL:

DATE:

Endura II™Tubular Yard Hydrant

(CONTINUED)

MOUNTING INSTRUCTIONS and PLUMBING CONNECTIONS

Provide solid, well-drained surface to mount hydrant (concrete pad recommended.) (6) 1⁄2" anchor bolts (not included) should be attached securely to mounting surface in order to secure fountain. (Refer to rough-in diagram.)

Locate and install plumbing through ground as required. NOTE: Hydrant is not furnished with service valve.

Position hydrant over plumbing and secure base to anchor bolts. Remove access panel and connect supply and water lines. Turn on water supply and check for leaks. Reassemble access panel to pedestal. Refer to owners’ manual for detailed instructions.

OPERATING PRESSURES:

Supply water - 105 psi maximum Hydrant is rated for inlet water pressure of 20-105 psi. A pressure reducing regulator should be used if the inlet water supply exceeds 105 psi.

NOTE: Not designed for sub-freezing applications.

Printed in the U.S.A.

FRONT VIEW SIDE VIEW

Model 4461

(With Locking Hose Bib)

Model 4460

TOP VIEW

LEGEND A = 1/2" O.D. UNPLATED COPPER TUBE CONNECT - SHUT OFF VALVE BY OTHERS