Halsey Taylor 4420 FR User Manual
This fountain is certified to
NSF/ANSI 61.
GENERAL
Pedestal, Endura II™Steel fountain with
textured powder-coat finish and E-coat
immersion for year-round beauty with minimum
maintenance. The E-coat immersion process
coats the outside and inside of the fountain for
the ultimate in corrosion protection. Contourformed stainless steel bi-level basins with
rounded corners and edges reduce splatter,
insure proper drainage and prevent standing
waste water. Designed to be easily accessible
to both physically challenged and able-bodied
individuals. Ideally suited for installation in
public areas. Model meets state and federal
requirements as defined by the Americans with
Disabilities Act.
FREEZE-RESISTANT VALVE SYSTEM
Freeze-resistant valve designed for ground
installation 18" below the frost line. 60" of
access tubing provided with the freeze-resistant
valve system. The length of the tubing can be
adjusted in the field for lesser frost depths.
BUBBLER
Vandal-resistant bubbler is one-piece,
chrome-plated. Unit has integral hood guard
design to prevent contamination from other
users, airborne deposits and tampering.
PUSHBUTTON ACTUATION MECHANISM
Self closing, vandal-resistant pushbutton does
not require grasping or twisting.
AUTOMATIC STREAM HEIGHT REGULATOR
Self-closing assembly is located inside unit to
prevent tampering. Unit resists corrosion and
liming. A constant stream height is automatically
maintained under line pressures that vary from
20 to 105 psi.
WATER INLET
3/8" female NPT fitting.
DRAIN OUTLET
Drain requirements are detailed in the owner’s
manual.
ACCESS PANEL
Manufactured of heavy-gauge steel with vandalresistant screws. Provides access for easy
hook-up of all plumbing connections.
SUGGESTED SPECIFICATIONS
Fountain shall include pushbuttons on the front
and side. Shall include contour-formed basins to
eliminate splashing and standing water, and shall
have rounded corners and edges. Projectors
shall be chrome-plated vandal-resistant type
with integral hood guard and anti-squirt feature.
Fountain shall comply with ANSI 117:1 and ADA
for visual and motion disabilities. The
manufacturer shall certify the unit to meet the
requirements of NSF/ANSI 61, and the Safe
Drinking Water Act.
Note: Continued product improvement makes
specifications subject to change without notice.
See Halsey Taylor website for most current
spec sheet.
Standard Finish is Evergreen textured
powder-coat Endura II
™
Each 4420 FR consists of 2 cartons of the
following:
Fountain
Freeze-Resistant Valve System
Service stop not included.
Shipping weight: 175 lbs.
HALSEY TAYLOR, 2222 CAMDEN COURT, OAK BROOK, ILLINOIS 60523
B28 / 6-2008
MODEL 4420 FR
Barrier-Free Fountain
Endura II™Tubular Pedestal
Freeze-Resistant Bi-Level
halseytaylor.com
JOB NAME:
ENGINEER/CONTRACTOR NAME:
APPROVAL:
DATE:
Printed in the U.S.A.
4420 FR
Freeze-Resistant
Barrier-Free
Endura
II
™
Tubular
Pedestal Fountain with
Twin Receptors
(CONTINUED)
MOUNTING INSTRUCTIONS and
PLUMBING CONNECTIONS
Site and drainage excavation is required for
fountain installation. Provide solid, well-drained
site and drainage surface to mount pedestal
fountain (concrete pad recommended.) (6)
1
⁄2"
anchor bolts (not included) should be attached
firmly to mounting surface in order to secure
fountain. Refer to rough-in diagram and be
sure to allow an opening for the freeze-resistant
valve in the ground as shown in the installation
instructions that accompany the fountain. Refer
to local codes for any additional requirements.
NOTE: Fountain is not furnished with service
valve. Assemble fountain to prepared site and
mounting pad.
Position pedestal over plumbing and secure
base to anchor bolts. Remove access panels
and connect supply and water lines. Turn on
water supply and check for leaks. Refer to
owner’s manual for detailed instructions.
OPERATING PRESSURES:
Supply water - 105 psi maximum
BACK VIEW
SIDE VIEW
TOP VIEW
LEGEND
A = ACCESS PANEL (8" x 10")
B = REMOVABLE BOTTOM COVER
C = 1" PVC DRAIN
D = PRESSURE FITTING
1-1/4" x 3/4"
E = CONNECTOR
1-1/4" TO 1-1/4"
F = 1-1/4" DRAIN TUBE
G = AIR CONTROL LINE
H = 1/4" WATER LINE
J = CONNECTOR FOR
AIR CONTROL LINE
*ADA Requirement
Loading...