Halsey Taylor 42522 User Manual
GENERAL
The cane touch apron is an optional accessory
designed to satisfy customer preference for
symmetry on HAC bi-level units as the bottoms
of the units are brought into line with each
other. Available in stainless steel or platinum
vinyl finishes. For use on all Halsey Taylor HAC
Series units. When installed properly, all HAC
units meet ADA requirements without the cane
apron. Overall dimension: 18" W x 6
1
/2" H x 8 3/4" D.
Note: Floor to underside measurements of
cane apron equals 27" when mounted correctly.
KIT CONSISTS OF:
■ Cane Apron
■ Screws
■ Installation instructions
Available finishes include:
■ Stainless Steel
■ Platinum Vinyl
Shipping Weight: 3.75 lbs.
TO ORDER:
Use part #73-42522-51-830
for stainless steel.
Use part #73-42522-51-410
for platinum vinyl.
Important: For use with units produced prior
to July 2007.
NOTE: Continued product improvement makes
specifications subject to change without
notice. See Halsey Taylor website for most
current spec sheet.
HALSEY TAYLOR, 2222 CAMDEN COURT, OAK BROOK, ILLINOIS 60523
E21 / 3-2009
42522 Cane Touch Apron
for HAC ADA Series
Cane Touch Apron
halseytaylor.com
42522 Cane Apron shown installed on
Halsey Taylor Model HAC8FSBL-Q ADA
JOB NAME:
ENGINEER/CONTRACTOR NAME:
APPROVAL:
DATE:
Printed in the U.S.A.
42522 Cane Touch Apron
for HAC ADA Series
(CONTINUED)
TOOLS REQUIRED
• Phillips Head Screwdriver
• Torx Head Driver
• Power Drill with 1/8" Drill Bit
• Hammer and Center Punch
INSTALLATION PROCEDURE:
1) Using template provided, mark hole
locations on front of left and right side panels.
TOP - Align with corner between side
panel and dispenser panel. (See Item - A)
OUTSIDE EDGE - Align with outside edge
of side panels. (See Item - B)
2) Drill 1/8" diameter holes at marked
locations. (Center punch hole locations
before drilling) When drilling the right hand
hole, on refrigerated units, be certain to drill
straight.
CAUTION: Keep the drill bit away from the
refrigeration condenser. If the drill damages
or punctures the condenser refrigeration
tubing, severe and expensive damage to
the refrigeration system will result.
3) Loosen and remove screws from underside
of cooler/fountain dispenser panels.
4) Install cane touch apron to underside of
cooler/fountain dispenser panels.
5) Reuse fasteners removed in step 3.
6) Attach lower edges of apron to cooler side
panels with screws provided. (Using two
holes drilled in step 2 above)
Loading...