Halsey Taylor 28813C Installation Manual

Installation Instructions

Cane Touch Apron

This kit is designed to be used with models

manufactured after July 2007.

Required Tools:

To install this kit the following tools are required:

• Phillips Head Screwdriver

• Pinned Torx Head Driver

• Power Drill with 1/8” Drill Bit

• Hammer and Center Punch

Installation Procedure:

1. Using cane apron as a template use a center punch to mark hole locations on front of left
and right side panels.

2. Drill 1/8” diameter holes at marked locations. (Center punch hole locations before drilling).
When drilling the right hand hole on refrigeration units, be certain to drill straight.
CAUTION: Keep the drill bit away from the refrigeration condenser. If the drill damages or
punctures the condenser refrigeration tubing severe and expensive damage to the
refrigeration system will result.

3. Loosen and remove (2) front screws from underside of cooler dispenser panels.

4. Install cane touch apron to underside of cooler dispenser panels and reuse fasteners removed
in step 3 above.

5. Att ach lower edges of apron to cooler side panels with screws provided. (Using two holes drilled
in step 2 above)

CANE TOUCH APRON COLOR OPTIONS

P ART NO.

28813C
28814C
28815C

FINISH

Stainless Steel
Platinum Vinyl

Light Gray Vinyl

98379C (09/07)

CANE TOUCH

APRON

STYLE OF C OO LE R

MAY VARY

UNIT W/O REFRIG.

SHOWN

SCREWS PRO VI DED

98379C (09/07)

1/8" DIA. HOLE (2)
(SEE NOTE 2)

(SEE NOTE 5)

FOR PARTS, CONTACT YOUR LOCAL DISTRIBUTOR OR CALL 1.800.323.0620