Halo Pocket Power 6000 Operating Instructions Manual
Operating Instructions
6000
Content
Warning 3-5
Illustration 6
Accessories 7
Operation Instructions 8
Specifications 9
Features 10-11
Demonstration 12-14
If the power charger does NOT charge your
mobile phone when the micro USB connector
is connected to your mobile phone, please
restart the power charger while it is connected
to your mobile phone (please refer to page 8 for
details.
2
Read all safety information and operating
instructions before using this HALO charger to avoid
possible injury and damage to your device. We
assume no responsibility for damage to charged
devices due to improper operations of this power
charger.
How to Handle
Do not drop, disassemble, open, crush, bend,
deform, puncture, shred, microwave, incinerate,
paint, or insert foreign objects into the HALO
charger.
Safety Information
Do not get the HALO charger wet. In case it does
get wet, unplug all cables and turn off power, by
pressing the power button for three seconds. Allow
it to dry thoroughly before turning it on again. Do not
attempt to dry the power charger with an external
heat source, such as a microwave or hair dryer. A
power charger that has been damaged as a result of
exposure to liquids is not serviceable.
Repair and Modification
Never attempt to repair or modify your HALO charger yourself. Disassembling this power
charger, including the removal of external screws,
may cause damage that is not covered under the
warranty. If this power charger has been
submerged in water, punctured, or dropped, do not
use it.
3
Battery Replacement
The rechargeable battery in your HALO charger
should be replaced only by HALO2CLOUD, LLC.
How to Recharge
Please use the built-in USB input connector to
recharge the HALO charger.
How to Use Connectors and Ports
Never force a connector into a port. If the connector
and port do not easily join, check for obstructions in
the port. If there are no visible obstructions, make
sure that the connector matches the port and that
you have positioned the connector correctly in
relation to the port.
How to Reboot
If there is an unexpected short circuit, the HALO
charger will shut down as a protective measure. In
case this happens, use the built-in USB cable, not
the power button, to reboot/turn on the HALO
charger.
Device and Accessories
1. Power button (turn ON/OFF)
2. LED power indicator lights
3. Micro USB output connector (5V/1A)
4. Recharge USB input connector
5. USB output port (5V/2A)
6. Standard USB tip
7. Micro USB tip
8. Lightning tip
9. 30-Pin tip
h
r
h
r
h
r
h
r
1
2
3
4
5
6
7
8
9
3-in-1 Cable
Loading...