Halo 5500 User Manual
Operating Instructions
1. Power Button
2. LED
3. Micro USB output connector
4. USB output port
5. Recharge USB input connector
Included Items
- 1 HALO Pocket Power 5500
- 1 USB to DC output cable
- 1 Mini USB tip
- 1 Micro USB tip
- 1 30 Pin tip
- Operating Instruction
Getting Started
Quickly press and release the power button to check how
much battery power the HALO charger has left. One blue
light indicates 0%-33% battery life, two blue lights indicate
34%-66% battery life and three blue lights indicate 67%100% battery life.
Turning On/O the HALO Pocket Power 5500
Press and hold down the power button for three seconds to
turn the HALO charger on. The LEDs will remain lit when the
power is on. Press and hold the power button for three
seconds to then turn HALO charger’s power o.
Charging the HALO Pocket Power 5500
To recharge the HALO charger pull the built in USB Cable,
found next to the words “USB in” on your HALO charger, out
from the top of the device. This built in USB cable is the only
cord that can be used to recharge your HALO charger. Once
this cable is pulled out from the HALO charger, plug the USB
input connector into the standard USB port on your computer or an AC wall adapter that accepts USB connections.
When recharging your HALO charger the three LED’s will
blink upwards from the bottom of the HALO charger where
the Power Button is located. When fully recharged all three
blue LEDs will remain a solid blue color.
Charging Your Personal Electronic Device
There are two methods that can be used to charge your
personal electronic device. The rst method involves using
the supplied USB charging cable. Plug the USB connector
into the bottom of your HALO charger where it reads “5V/2A
out”. Find the tip that ts with the electronic device you are
Loading...