Magic Power Cube 3000
OPERATING INSTRUCTIONS
Diagram
Power Button
USB Out
Fuel Gauge (Battery Status Indicator)
Car Plug-In
Wall Plug-In
Included Items
- 1 HALO Magic Power Cube 3000
- 1 HALO Charge It Charge MeTM cable
- 1 30-pin adapter tip
- 1 Carrying pouch
- Operating Instructions/ Warranty
Getting Started
Charge the HALO Magic Power Cube 3000 until the LED displays
solid green (no lights should be ashing). This will take up to six
hours and will vary depending on whether the unit is charged
from a wall outlet or car.
To Turn On/O the HALO Magic Power Cube 3000
The HALO charger will automatically turn on and begin charging
as soon as it is plugged into your personal electronic device. To
preserve the battery, the HALO charger will automatically turn o
after two minutes if your personal electronic device is fully
charged and no longer drawing power. The unit may also be
turned on/o by manually pressing and holding the power
button for three seconds.
Power Indicator/Battery Status
When charging/discharging, the LED will ash one of the following colors indicating the amount of battery level remaining: red
(1%–33%), orange (34%–66%) or green (67%–99%). The power
status can also be checked by pressing and releasing the power
button when the unit is not in use. When the HALO charger is
100% charged, the green LED will stop blinking and turn solid
green.
Charging the HALO Magic Power Cube 3000
Charge your HALO charger using the built-in wall or car plug. If
charging indoors, plug the wall adapter into a wall outlet. If
charging on the go, plug the car adapter into the car lighter
outlet. Depending on how much charge your HALO charger
already has, the charging indicator light will ash green, orange,
or red, indicating your HALO charger is properly charging.
Charging Your Personal Electronic Device
Charge your personal electronic device using the supplied
HALO Charge It Charge Me cable. Plug the USB connector into
your HALO charger. Insert the provided appropriate tip into
your personal electronic device and charging will begin
automatically. You may also use your own USB cable that was
supplied with your personal electronic device. While your
personal electronic device is charging, the LEDs will continue
to illuminate, indicating the HALO charger’s remaining capacity. The red LED lights will begin to ash prior to the HALO
charger running out of power.
Note: To charge both the HALO charger and your personal
electronic device, rst plug the HALO charger into either a wall
outlet or car outlet. Using the supplied HALO Charge It Charge
Me cable, connect your personal electronic device to the HALO
charger and your personal electronic device will automatically
begin to charge. Once your personal electronic device is fully
charged, the HALO charger will then begin to charge itself.
Storing/Handling/Cleaning the
HALO Magic Power Cube 3000
- Do not get wet or store in extreme temperature conditions.
- Do not disassemble the HALO charger or attempt to repair it.
- Use a soft cloth with soap to clean the exterior of your HALO
charger. Do not use liquid detergent or chemicals of any
kind.
Safety Precautions
This HALO charger has been designed and manufactured to
ensure personal safety. Please read the following carefully
before using. Incorrect operation or incompatibility with your
personal electronic device may result in reduced battery
performance or damage.
- Carefully read the operating instructions, and use the HALO
charger correctly.
- Caution: The lithium-ion rechargeable battery used in this
charging device may present a risk of re or chemical burn if
mistreated. Do not disassemble, expose to heat above 212°F
(100°C) or incinerate.
- Misusing or incorrectly connecting the HALO charger may
cause electric shock to users and damage equipment. The
HALO charger may become warm under extended high
power operation. During operation, keep the HALO charger
away from materials that may be aected by these tempera
tures.
- When used correctly, lithium-ion rechargeable batteries
provide a safe and dependable source of portable power.
However, if they are misused or abused, this may result in
leakage, burns, re or explosion, causing personal injury or
damage to other devices.
- Do not disassemble the HALO charger. There are no user serviceable parts inside. Incorrect reassembly may result in
shock or re hazard.
- Do not drop or subject to strong impacts. Do not operate
the HALO charger if it has received a sharp blow, or other
wise been damaged in any way.
- Do not expose the HALO charger to moisture, water, rain, or
snow.
- Do not insert any object into the ports or openings of the
HALO charger.
- Never charge the HALO charger unattended.
- There is a risk of the batteries exploding, overheating, or
igniting. Do not disassemble, modify, heat or short-circuit
the batteries. Do not place in re or leave in hot places. Do
not expose to direct sunlight.
- Only charge the HALO charger by the specied method with
the specied USB cable.
- In the unlikely event of leakage or explosion use sand or a
chemical re extinguisher.
- Batteries should be recycled or disposed of as per state and
local guidelines.
Specications
Battery: Rechargeable Lithium Polymer
Power Capacity: 3000mAh
Output Volt: DC 5V
Rated AC Input: 110V~240V
Rated DC Input: 12V~24V
Output Voltage (DC): 1000mA
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
- This device may not cause harmful interference,
and
- This device must accept any interference received,
including interference that may cause undesired
operation.
15.21
You are cautioned that changes or modications not expressly
approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
15.105(b)
This equipment has been tested and found to comply with the
limits for Class B digital devices, pursuant to Part 15 of the FCC
rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which
can be determined by turning the equipment o and on, the
user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit dierent
from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for
help.
Limited Warranty
HALO2CLOUD, LLC warrants its products to be free from defects
in material and workmanship under normal use conditions, as
follows:
- During the rst one year from date of purchase, HALO2CLOUD,
LLC will repair or replace the defective product.
- HALO2CLOUD, LLC will, subject to inspection, repair the
defective product or replace it with a new or reconditioned
unit. The return must be accompanied by a Return Materials
Authorization (RMA) number to be issued upon request and
must be shipped prepaid. A shipping rebate will only be
extended to the customer in the event that a defect in material
or workmanship is conrmed.
- Warranty is void if the product has been improperly handled
or misused in any way, or if the label and/or bar coded
warranty label has been removed or tampered with.
- Warranty returns require a check for $14.95 for processing and
handling made payable to HALO2CLOUD, LLC.
- Where applicable, all requests for warranty returns must be
accompanied by a proof of purchase and be sent to
HALO2CLOUD, LLC (www.halo2cloud.com).
- The warranty does not extend to the electronic equipment
that is used or which incorporates with any of our products
and accessories. HALO2CLOUD, LLC shall not be held
responsible for the improper use of its products.
To contact us, email us at
support@halo2cloud.com
or call 888-907-6274
The HALO cloud logo and
HALO Charge It Charge Me cable
are registered trademarks of
HALO2CLOUD, LLC
148 Eastern Boulevard, Suite 210
HALO2CLOUD, LLC
Glastonbury, CT 06033
www.halo2cloud.com
Loading...