Hall Research VHD-PCTV User Manual

Page 1
User’s Manual
UMA1190 Rev NC
CUSTOMER SUPPORT INFORMATION
VHD-PCTV
VGA to Video Scan Converter
Page 2
Page 3
VGA to Video Scan Converter
1
TRADEMARKS USED IN THIS MANUAL
Hall Research and its logo are trademarks of Hall Research. Any other trademarks mentioned in this manual are acknowledged as
the property of the trademark owners.
FEDERAL COMMUNICATIONS COMMISSION
RADIO FREQUENCY INTERFERENCE STATEMENT
This equipment generates, uses, and can radiate radio frequency energy and if not installed and used in strict accordance with the manufacturer’s instructions, may cause interference to radio communication. This equipment is designed to comply with the limits for a Class A computing device in accordance with the specifications in Subpart B of Part 15 of FCC rules, which are intended to provide reasonable protection against such interference when the equipment is operated in a commercial environment. Operation of this equipment in a residential area is likely to cause interference, in which case the user at their own expense will be required to take whatever measures may be necessary to correct the interference. Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.
Page 4
VHD-PCTV
2
Contents
1. Introduction .................................................................3
1.1 General ...................................................................... 3
1.2 Features..................................................................... 3
2. Hardware .....................................................................4
2.1 Operation ................................................................... 4
3. Specifications .............................................................5
Page 5
VGA to Video Scan Converter
3
1. Introduction
1.1 General
This User’s Manual applies to Hall Research VHD-PCTV. The VHD-PCTV converts a PC video signal to NTSC or PAL format
on S-Video or Composite cable. It supports Overscan or Underscan via a selector switch.
The VHD-PCTV is very simple to setup and use. Just connect the video input and output cables, plug it in and the unit is ready to go. The LED on the top of the unit indicates the device has power and is operational.
1.2 Features
Converts and scales PC signal to interlaced NTSC or PAL
video
Supports resolutions up 1600x1200  Image Overscan or Underscan selection  Quick and simple to install  Compact size
Page 6
VHD-PCTV
4
Figure 3 - Front Panel
Figure 3 - Rear Panel
Figure 3 - Side Panel
Figure 4 - Top Panel
2. Hardware
2.1 Operation
1. Connect Input from PC.
2. Connect 5v power.
3. Connect video output via S­Video or Composite cable.
4. Select Overscan or Underscan.
5. Select NTSC or PAL format.
6. Turn unit On/Off via Power button. LED indicates device power status.
a. Green LED – Unit Ready. Press and hold power
button to put in standby.
b. Red LED – Unit is in standby. Press power button to
make active.
c. LED off – Unit has no power.
Page 7
VGA to Video Scan Converter
5
Video
Inputs
PC (HD15)
Outputs
Composite (RCA) / S-Video
General
Power Supply
5 VDC, 1 A, regulated; 2.1mm
Temperature/humidity
Storage: -40 to +158 °F (-40 to +70 °C) 10% to 90%, non-condensing
Operating: +32 to +104 °F (0 to +40 °C) 10% to 90%, non-condensing
Enclosure type
Plastic
Dimensions
0.72" H x 3.9" W x 2.5" D (18.5 mm H x 100 mm W x 64 mm D)
Product weight
0.22 lb (100 g)
MTBF
90,000 hours
Warranty
2 years parts and labor
Specifications are subject to change without notice
3. Specifications
Page 8
Order toll-free in the U.S. 800-959-6439 FREE technical support, Call 714-641-6607 or fax 714-641-6698 Mail order: Hall Research, 1163 Warner Ave. Tustin, CA 92780 Web site: www.hallresearch.com E-mail: info@hallresearch.com
CUSTOMER SUPPORT INFORMATION
© Copyright 2010. Hall Research, Inc.
All rights reserved.
Loading...