Order toll-free in the U.S. 800-959-6439
FREE technical support, Call 714-641-6607 or fax 714-641-6698
Mail order: Hall Research Technologies, 1163 Warner Ave, Tustin, CA 92780
Web site: www.hallresearch.com • E-mail: info@ hallresearch.com
UMA1135, Rev 5
UV-16 Family of Mini-Cat® Senders
TRADEMARKS USED IN THIS MANUAL
Hall Research, HR, and (logo) are trademarks of Hall
Research, Inc. Any other trademarks mentioned in this manual are
acknowledged to be the property of the trademark owners.
FCC & CANADIAN DEPARTMENT OF COMMUNICATIONS
RADIO FREQUENCY INTERFERENCE STATEMENTS
This equipment generates, uses, and can radiate radio frequency energy
and if not installed and used properly, that is, in strict accordance with
the manufacturer’s instructions, may cause interference to radio
communication. It has been designed and found to comply with the
limits for a Class A computing device in accordance with the
specifications in Subpart B of Part 15 of FCC rules, which are intended
to provide reasonable protection against such interference when the
equipment is operated in a commercial environment. Operation of this
equipment in a residential area is likely to cause interference, in which
case the user at their own expense will be required to take whatever
measures may be necessary to correct the interference.
This digital apparatus does not exceed the Class A limits for radio
noise emission from digital apparatus set out in the Radio Interference
Regulation of the Canadian Department of Communications.
Le présent appareil numérique n’émet pas de bruits radioélectriques
dépassant les limites applicables aux appareils numériques de la classe
A prescrites dans le Règlement sur le brouillage radioélectrique publié
par le ministère des Communications du Canada
EUROPEAN UNION DECLARATION OF CONFORMITY
This product has been tested and shown to comply with the
requirements of the European EMC directive 89/336/EEC
This User’s Manual covers several models of Mini-Cat® Senders. The
senders can be any of the following models: UV1-S-16X or UVA-16X.
For these units, the number after the dash represents the quantity of
RJ45 outputs.
The transmission system is comprised of one Rack-Mount Sender unit
and one or more Receiver units (Sold Separately). There are 2
variations of the basic sender which can transmit Video along with
either Phantom Power (UV1-S-16X) or Video along with Line-Level
Audio (UVA-16X).
The senders convert the video inputs and either power or audio signals
into a format that can be transmitted using a single inexpensive and
commonly available Unshielded Twisted Pair (UTP) cable with RJ45
connectors. Both UTP and STP (shielded) cables can be used. In
addition you can use Cat5, 5e, 6, or higher. However, for runs of over
250 feet, Hall Research recommends using “Skew-free” or “Zeroskew” Cat5 cables for best performance.
At the receiving (remote) end, a compatible receiver (sold separately)
is used to convert the UTP signal back to VGA and either power, audio
or RS232.
The product is housed in a 2 RU, 19” Rack mount enclosure and has
connectors for up to 16 video inputs and Audio depending on the
model, as well as multiple RJ45 output connectors for connection to the
remote systems.
The RJ45 outputs on the Sender can drive CAT5 LAN cables to 1000
feet (305 meters) with little to no degradation of video quality (500 feet
on some models) depending on resolution of the VGA signal (see table
3.2). The receiver can compensate for video signal losses in long cable
runs.
3
Loading...
+ 11 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.