CUSTOMER
SUPPORT
INFORMATION
SC-CSV-HDMI
Composite & S-Video
To
HDMI Video Processor
UMA1173 Rev. NC
Order toll-free in the U.S. 800-959-6439
FREE technical support, Call 714-641-6607 or fax 714-641-6698
Mail order: Hall Research, 1163 Warner Ave. Tustin, CA 92780
Web site: www.hallresearch.com E-mail: info@hallresearch.com
VGA / HDTV Video Processor
TRADEMARKS USED IN THIS MANUAL
Hall Research and its logo are trademarks of Hall Research.
Any other trademarks mentioned in this manual are
acknowledged to be the property of the trademark owners.
FEDERAL COMMUNICATIONS COMMISSION
RADIO FREQUENCY INTERFERENCE
STATEMENT
This equipment generates, uses, and can radiate radio
frequency energy and if not installed and used properly, that is,
in strict accordance with the manufacturer’s instructions, may
cause interference to radio communication. It has been
designed to comply with the limits for a Class A computing
device in accordance with the specifications in Subpart B of Part
15 of FCC rules, which are intended to provide reasonable
protection against such interference when the equipment is
operated in a commercial environment. Operation of this
equipment in a residential area is likely to cause interference, in
which case the user at there own expense will be required to
take whatever measures may be necessary to correct the
interference.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.
This digital apparatus does not exceed the Class A limits for
radio noise emission from digital apparatus set out in the Radio
Interference Regulation of the Canadian Department of
Communications.
1
Model SC-CSV-HDMI
Contents
1. Introduction.............................................. 3
1.1 General................................................................ 3
1.2 Features .............................................................. 3
2. Installation................................................ 4
2.1 Connections......................................................... 4
2.2 Connection Block Diagram .................................. 4
3. Configuration & Operation...................... 5
3.1 Input and Output.................................................. 5
3.2 Menus and Adjustments ...................................... 5
4. Troubleshooting ...................................... 8
4.1 Contacting Hall Research .................................... 8
4.2 Shipping and Packaging ...................................... 8
5. Specifications .......................................... 9
5.1 General................................................................ 9
5.2 Output Resolutions Available............................... 9
2
VGA / HDTV Video Processor
1. Introduction
1.1 General
The SC-CSV-HDMI has the ability to scale the analog video
signal from Composite and S-Video sources into a digital HDMI
output with a wide range of HDTV and PC resolutions; up to
1080p.
Along with scaling the video, the SC-CSV-HDMI converts the
input analog or digital optical fiber (TOSLink) audio signals into
both an analog and digital format for simultaneous output on the
HDMI, Optical Fiber (TOSLink) and analog 3.5mm L/R
connectors.
The SC-CSV-HDMI has an easy to use OSD menu for
configuration, picture setup, system information and other
advanced options.
1.2 Features
• HDMI 1.2, HDCP 1.1 and DVI 1.0 Compliant
• Scales CV or SV analog video to PC (VGA-WUXGA) or
HD(480i-1080P) resolutions
• Can automatically detect the connected monitors’
NATIVE resolution and adjust the output scaling to
match.
• Supports 50/60 Hz frame rate conversion
• Supports 3D motion video adaptive, 3D de-interlacing
and 3:2/2:2 pull down detection and recovery
• Provides OSD with contrast, brightness, hue, saturation,
sharpness, RGB (color tone) and aspect ratio size
• Supports high resolution output
• Supports stereo LPCM analog/digital audio input and
stereo LPCM analog/digital output.
• Easy- to- use push buttons and OSD menu control.
3
Model SC-CSV-HDMI
2. Installation
2.1 Connections
Connect the video source to the Composite and/or S-VIDEO
video input connectors.
Connect the audio source to the analog L/R input connectors or
use the TOSLink connecter if using an optical fiber audio input.
Connect the display device to the HDMI output connector
Connect the audio output device to either 3.5mm Audio output
connector or the TOSLink (Optical Fiber) connector. Note that
audio comes from all simultaneously.
2.2 Connection Block Diagram
Figure 1 – Connection Block Diagram
4
VGA / HDTV Video Processor
3. Configuration & Operation
3.1 Input and Output
Figure 2 - Input
Figure 3 - Output
3.2 Menus and Adjustments
Pressing the Menu button will bring up the OSD menu controls
on the screen. Use the up and down arrows to select the desired
item, and then press MENU to select and enter into that items
sub menu. Select EXIT from a submenu to go back to the main
menu or from the main menu to exit the OSD.
CONTRAST
Adjusts image contrast (default = 25)
BRIGHTNESS
Adjusts image brightness (default = 50)
5
Model SC-CSV-HDMI
FINETUNE
When selected, a sub menu of input signal capture adjustments
will appear.
HUE – (default = 48)
SATURATION – (default = 63)
SHARPNESS – (default = 20)
NOISE REDUCTION - (default = off)
COLOR
When selected, a sub menu of input signal capture adjustments
will appear.
RED – Adjust RED RGB value (default = 50)
GREEN – Adjust GREEN RGB value (default = 50)
BLUE – Adjust BLUE RGB value (default = 50)
SIZE
Select this option to toggle between FULL, PANSCAN,
LETTERBOX, UNDERSCAN or OVERSCAN display modes.
6
OUTPUT
Use arrows to adjust output mode. Refer to Section 5.2 below for
a list of all available modes.
The default output resolution after a factory reset is “NATIVE”
with the input source set to “AV”.
The unit has non-volatile memory and memorizes all your
settings before power off and recalls those settings on the next
power on.
At any time, pressing the UP ARROW ▲ and MENU button
together will change the output resolution to XGA@60Hz.
Pressing the MENU and DOWN ARROW ▼ together will
change the output resolution to 480P@60 Hz.
OSD
When selected, a sub menu of input signal capture adjustments
will appear.
H-POSITION – Adjust horizontal position of the OSD on the
screen. (default = 10)
V-POSITION – Adjust vertical position of the OSD on the screen.
(default = 90)
VGA / HDTV Video Processor
TIMER – Select the number of seconds for the OSD to be
displayed on the screen before turning off. (default = 10)
BACKGROUND – Changes opacity of the OSD background on
the screen. (default = 63)
Factory Reset
Select this option to reset all values to the factory defaults. Since
this sets the INPUT source as “AV”, you may need to select the
“S-VIDEO” source by pressing the “-“ button with no OSD
selected to get a picture.
Information
Displays source type, Input resolution, output resolution and
firmware version.
Mirror
If enabled; this function will flip the image horizontally on the
screen.
7
Model SC-CSV-HDMI
4. Troubleshooting
There are no field serviceable parts or circuits in the device. If
you think that the device is malfunctioning (or you have no
picture output), please first try to reset to factory default settings.
4.1 Contacting Hall Research
If you determine that your SC-CSV-HDMI is malfunctioning, do
not attempt to repair the unit. Contact the Hall Research
Technical Support department at 714-641-6607.
Before you do, make a record of the history of the problem.
We will be able to provide more efficient and accurate
assistance if you have a complete description.
4.2 Shipping and Packaging
If you need to transport or ship your unit:
• Package it carefully. We recommend that you use the
original container.
• Before you ship the units back to Hall Research for repair or
return, contact us to get a Return Authorization (RMA)
number.
8
VGA / HDTV Video Processor
5. Specifications
5.1 General
Input ports (1) RCA (CV)
(1) S-VIDEO
(1) TOSLink (Optical Fiber Input)
(2) RCA (Audio L/R)
Output ports (1) HDMI Output
(1) 3.5mm Analog Audio Output
(1) TOSLink (Optical Fiber Output)
Power Supply 5V/2.6A DC (CE/FCC/UL certified)
Dimensions 4” (W) x 7.375” (D) x 1” (H)
(101.6mm) x (187.3mm) x (25.4mm)
Weight 0.90 Lbs (0.41kg)
Chassis Aluminum
Operating Temp 32 to 122 DegF (0 to 50 DegC)
5.2 Output Resolutions Available
Output Resolutions Available
NATIVE
640x480 (VGA) 60 Hz
800x600 (SVGA) 60 Hz
1024x768 (XGA) 60 Hz
1280x800 (WXGA) 60 Hz
1440x900 (WXGA+) 60 Hz
1280x1024 (SXGA) 60 Hz
1400x1050 (SXGA+) 60 Hz
1600x1200 (UXGA) 60 Hz
1680x1050 (WSXGA) 60 Hz
1920x1200 (WUXGA) 60 Hz
480I 60 Hz
480P 60 Hz
576I 50 Hz
576P 50 Hz
720P50 50 Hz
720P60 60 Hz
1080I50 50 Hz
1080I60 60 Hz
1080P50 50 Hz
1080P60 60 Hz
9
Model SC-CSV-HDMI
10
VGA / HDTV Video Processor
11
Model SC-CSV-HDMI
12
CUSTOMER
SUPPORT
INFORMATION
© Copyright 2009. Hall Research, Inc.
All rights reserved.
Order toll-free in the U.S. 800-959-6439
FREE technical support, Call 714-641-6607 or fax 714-641-6698
Mail order: Hall Research, 1163 Warner Ave. Tustin, CA 92780
Web site: www.hallresearch.com E-mail: info@hallresearch.com
Loading...