H
all Research Technologies, Inc
1163 Warner Ave.
Tustin, CA 92780
Phone: (714) 641-6607
Fax: (714) 641-6698
MMooddeell EEXX--HHDDMMII--22AA UUsseerr’’ss MMaannuuaall
UUMMAA11009988 RReevv.. A
HDMItm Cable Extender & Equalizer
Boosts the Digital HDMI™ Video+Audio
Signal
Extend your HDMItm Video and Audio Signal to over
100 feet
Connect up to 65 feet of HDMI
and/or Output
tm
HDCP
Compatible
tm
Cable to the Input
A
© Hall Research, Inc. All Rights Reserved
HDMI is a registered trademark of HDMI Licensing LLC
Product Description
The EX-HDMI-2A HDMI Extender is a digital signal booster that corrects the signal
degradation that occurs in long HDMI cables. It is perfect for extending a HDMI display
away from the signal source.
If you need to use a long cable to connect your display (such as HDTV) to your video
source, you may see pixilation, sparkles, or loss of video and/or audio when connected
directly using cables longer than about 15 feet. To reconstruct the digital signals, you
need to use an equalizer such as the EX-HDMI-2A. It compensates for the losses of the
LVDS signals on its input, and it also features a switchable boosted video output that can
drive long cables. With quality HDMI copper cables, you can extend 1080p or 1920x1200
resolutions up to about 130 feet total (65 ft on the input and 65 feet on the output).
Package Contents
• The Extender Unit (measures 2.76 x 3 x 1.3 inch)
• A power supply (Switching supply with 100~240 VAC, 5VDC @ 2.5A output)
• This User’s Manual
Features
¾ Provides to 2.5 times gain on input to compensate for long HDMI cable loss
¾ Extend cable reach to 130 feet - 65 feet each side
¾ Maintains high HDMI link with video resolution up to UXGA/1080p.
¾ HDCP compliant. Plug and play, easy to install.
¾ Can be powered directly from the video source, but also includes power supply
¾ Backward compatible with DVI (adapter needed)
Setup and Operation
For extension of the HDMI signal up to 65 feet, place the EX-HDMI-2A at the remote end
(display end). For longer extensions place the EX-HDMI-2A in the middle of the cable,
i.e. connect a 65 ft cable to the input and up to 65 ft cable on the output. When extending
the output set the Enhance Switch to the ON position. To achieve these distances you
must use high quality HDMI cables. Your results may vary. Contact Hall Research for
your HDMI cable needs.
© Hall Research, Inc. All Rights Reserved
HDMI is a registered trademark of HDMI Licensing LLC
Loading...