Halfords 2-in-1 Bike Trailer Owner's Manual And Safety Instructions
2-in-1 Bike Trailer
Owner’s manual
and
safety instructions
Owner’s Manual
Every effort has been made to ensure your trailer is of top quality and proven safe design, ready to provide you with
many years of safe, happy use. Please read this manual and instructions fully before assembly and use.
Please keep this manual for future reference. If you sell or give this product to someone else, please include this
Owner’s Manual, and ask the new owner to read the instructions thoroughly before using.
WARNING Your trailer is designed for the safe, passive transportation of 1 child or 2 children between 12 months
and 6 years of age and weighing no more than 22kg (48lbs) each. It designed only for attachment to an adult
pedal cycle and for use at a leisurely pace. Its design is not consistent with off-road, jumping or competitive
cycling.
Any such unauthorized use may cause a critical failure of the trailer resulting in possible death or injury
to the passenger(s) and/or rider.
WARNING Not for use with children under 12 months old! Children must be able to support their own heads!
WARNING To prevent injury, please use extreme care when folding and unfolding this product!
PRIOR TO ASSEMBLY
Your Halfords trailer is 95% factory assembled. You need only install the safety flag, and attach the wheels
before it is ready to use. This initial assembly should only take around 10-15 minutes, after which all you
need do now is familiarize yourself with the essential safety information within this document and you’re ready to go.
Assembly and attachment must only be carried out by an adult.
Check that all parts are present. If any parts are missing or damaged, please contact one of our Customer Service
Representatives by phone at 01332 274242, or by e-mail at customer.sevice@moorelarge.co.uk
WARNING Immediately discard all plastic bags and plastic wrapping materials!
WARNING Never allow children to assemble, fold, or disassemble this unit!
PARTS LIST
1 Frame with canopy, sling seat with twin 5-point safety harnesses, tow bar, tow bar coupler and rear wheel
brackets attached.
1 2-in-1 Rain cover
1 Safety flag with pole
2 20” Rear wheels
1 Front wheel assembly
1 Stroller handlebar
1 Safety wrist strap
No tools are required to assemble this trailer. However, for those bikes without a quick-release axle on the
rear wheel, an adjustable wrench is required to attach the coupler plate.
WARNING Before using, be sure the product is correctly assembled!
ASSEMBLY INSTRUCTIONS
1A 1B
1A. Remove all of the contents from inside the carton and place them on a clean flat surface. Check all the
contents against the parts list on page 1. Check the contents also for damage.
1B. Set the wheels to the side and remove the black plastic prote c t i v e caps from the ends of the axles.
Remove the rain canopy and flag pole assembly from inside the trailer.
STEP 2 Assemble the canopy frame
2A
2B 2C
2A. Lift the left side panel with the frame joiner housing upward so that the right side panel is visible.
Lift the right side panel to expose the crossbar and slide the crossbar through the sling seat.
Locate the end of the crossbar into the joiner housing on the left panel.
2B. Insert the quick release safety pin through the end of the cross bar & joiner housing and snap closed.
2C. Insert the quick release safety pi ns through the front and rear of each panel at the base and snap closed to
secure the sides.
WARNING Ensure all 5 quick release safety pins are securely locked before continuing!
Q/R safety pin
Q/R safety pin
Loading...