Haier Telecom 0901HC-CM220 Users Manual

Multilinks Data Card

Help

1

Welcome

Welcome to use Multilinks Data Card. With it, you can dial-up to the network, Send SMS, Call,
Manage Contacts, and so on. This guide aims to introduce how to use Multilinks Data Card.

RF exposure information:

FCC RF Exposure requirements: The highest SAR value reported under this standard during
product certification for use next to the body is 0.728 W/kg. This transmitter must not be
collocated or operating in conjunction with any other antenna or transmitter. USB dongle
transmitter is approved for use in typical laptop computers. To comply with FCC RF exposure
requirements, it should not be used in other devices or certain laptop and tablet computer
configurations where the USB connectors on the host computer are unable to provide or ensure the
necessary operating configurations intended for the device and its users or bystanders to satisfy RF
exposure compliance requirements.

This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.

NOTE: The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user’s authority to
operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

-Consult the dealer or an experienced radio/TV technician for help

2

Install

This section will introduce how to install Multilinks Data Card. The content includes the following:

Install driver

Install and uninstall software

Install Data Card

Install driver

It is recommended that you should firstly install this driver before run the Software or insert the
data card into your computer. Please check the following operation under XP operation system.

1. Run msi file under the directory "USB Data Card Driver".

2. Please click "Next" in driver installation interface.

3. Please click "Install" in this interface.

3

4. While waiting for the installation, install progress is also being displayed. When the driver is
being installed, Operation System may show a message "Digital Signature Not Found" or "has not
passed Windows Logo testing to verify its compatibility with this version of Windows", please
select "Yes" or "Continue Anyway" to complete the installation.

4

5. Finish installation.

5

Install and uninstall software

Install software

The installation program of the software has been packaged as an executable file. Please check the
following operation under XP operation system.

1. Run exe file under the directory "Data Card Soft".

2. Please select "Next" in Software Installation interface.

3. Please select "I accept the agreement" and "Next" in License interface.

6