Contents marked with that symbol are related to the
safety of the product and the personal safety of the
users. Please operate in strict conformity to the contents,
otherwise it may cause damage of the machine or
injure the personal safety of the user.
Attachment block
(2 pieces)
Lint filter(2 pieces)
Liquid bleacher
inlet
Pulsator
Handle(2 pieces)
Cabinet
Cabinet base
Adjustable leg
Forbidden sign
Contents marked with that symbol are actions forbidden
to perform. Performing of those actions may result
in damage of the machine or injure the personal
safety of the user.
1
Safety precautions
Please insert the power cord into special receptacle
with rated voltage. Be sure to use single-phase three
pins receptacle. Ensure the earthing prong of the
power receptacle is earthed reliably. Use leakage
protector if possible.
Do not bend, stretch, twist, bind the power cord by force, or reform it.
Do not press or clamp it with heavy items. If the power cord and power
plug are bad, or the receptacle is loose, be sure to have it replaced by
the technicians of our special shop or our agent, or the after-sales service
department to avoid any risk. Keep the prong of the power plug clean. If
dust is found on the power plug, please wipe it off with dry cloth.
In case the washing machine is installed on ground
with carpet, be careful not to block the ventilation hole
with carpet.
The ventilation
holes at the bottom
In common usage of the washing machine, the power
plug shall be ready to be pulled or plugged with hand.
Be sure to pull the plug off and close the water faucet
when occurring power failure, delivering the machine,
setting the machine idle or cleaning the machine. Do
not plug or pull the power plug with wet hand.
Do not use water with temperature higher than 50
Do not put the machine at damp place like the
bathroom. Never wash it with water. Do not
put wet laundries on the control panel coating.
Do not let the machine share one receptacle with other
electric appliances. If the power plug is damaged, or
the plugging into the receptacle is loose, do not use
the plug any more.
Do not wash water-proof laundry like the raincoat,
bike covers etc. To avoid abcommon vibrations in
spinning and damages to the laundries.
2
Safety precautions
Do not put hand into the rotating tub. It is dangerous
even if the rotation speed is slow. Take special care of
the children. Keep children away from the washing
machine to avoid them climbing on.
Do not put any hot or heavy items (such as the
kettle with hot water) on the washing machine.
The handicapped or Children without care shall not
use the machine.
Do not decompose, repair or alter the machine by
yourself.
Do not wash laundry with volatile materials
(such as thinner, petrol etc.).
Benzene
Keep the machine away from direct sunlight and
heat source like the heater.
Please keep the lint filter in good
condition, and install it to proper
position during washing. If
the lint filter is lost or damaged,
please contact the local after-sales
service department of our company.
Please check if the water faucet is open, and if the connection of the water inlet pipe is proper before washing.
Please put down the drain hose before washing.
It is suggested to use foamless washing powder.
Please don't use the washer in the environment below 0if the washer has been stored below 0please
be sure to ensure the washer is placed under the room temperature for 24 hours and then use otherwise the
washing effects may be lowered or the washer may be damaged.
Install
To protect your laundries and washing machine,
please take out all of the coins, buttons, sand, hairpin
and other foreign materials before washing.
Dismantle
3
Installation and adjustment
Please install and adjust the machine according to the requirement of the manual.
It is very important to your security and correct operating the machine.
Install the inner cover component
1.Open the top lid of the washing machine.
2.Put the inner cover component on the outer tub cover,
aiming the inner cover shaft to the installation hole of the
corresponding outer tub cover shaft groove.
3.Firstly insert the inner cover shaft of one side into the
corresponding outer tub cover shaft groove, then push
the another inner cover shaft into the corresponding
outer tub cover shaft groove. Please install to designated
position to guarantee there are no dropping or abcommon
sound in opening and closing of the inner cover, and the
operation shall be smooth. Do not dismount the inner
cover component after washing.
Install the bottom plate
After opening the package, please lean the washing
machine gently down on soft items (like towel cloth,
blanket, etc.). Install the bottom plate to the bottom
of the machine with four screws by a cross screwdriver,
then lift the machine up gently.
See to the figure:
Front
Outer tub cover
Outer tub cover
shaft groove
Inner cover shaft
Inner cover
Right hand
Left hand
Back
Bottom plate
Screw
Soft object
4
Loading...
+ 14 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.