Disposal after washing......................................15
Trouble shooting answer to question................16
Packing list Specification
.....................................1
....
.......4
....
......8
.....9
.....9
.......10
.......
.......
.......
.......
.....................................17
Names of the parts
Top lid components
Inner cover components
Detergent box
Control panel seat
Outer tub cover
Balance ring
Attachment block 3 pieces
Inner tub
Lint filter
Pulsator
Control panel coating
Cabinet
Liquid blenching filler
Adjustable leg
Water absorption
cushion
Power cord
Drain hose
Back cover
Water inlet valve
Rear faceplate
The figure in this manual being sketch map and with the improvement of our products, the machine you buy
is like to be different from the figure indicated in the manual .Please understand.
Meaning and description of the symbols
Draining hose
hanging hole
Handle
Warning sign
Forbidden sign
Contents marked with that symbol are related to the safety of the product
and the personal safety of the users. Please operate in strict conformity to
the contents, otherwiseit may result in damage of the machine or influence
the personal safety of the users.
Contents marked with that symbol are actions forbidden to perform.
Performing of those actions may result in damage of the machine
or influence the personal safety of the users.
1
Safety precautions
Please plug the power plug on special
receptacle. Be sure to use three-pins
power receptacle. Ensure that the earthing
prong of the power receptacle is earthed
reliably. Use leakage protector if possible.
Earth
Do not bend ,extend,twist,bind by force.Do not press or nip it with weight.
Keep the pin of the power plug clean,if the power plug is polluted with dust,please wipe with
dry cloth carefully.
If the power cord or the power plug is bad, to avoid risk it is
required to have it replaced by the technicians of our
special shop or the after-sale service department.
In case the washing machine is installed on ground with
carpet, do not block the ventilation hole with carpet.
The ventilation
holes at the bottom
Soft object
The washing machine must be positioned
so that the plug is accessible. Be sure to pull the
plug off and close the water faucet in
following cases: power failure, delivering
the machine, setting the machine idle or
cleaning the machine. Do not plug
or pull the power plug with wet hand.
Do not use water hotter than 50
Do not put the machine at damp place like
the bathroom. Never wash it with water. Do
not put wet laundries on the control panel.
Do not let the machine share one receptacle with other
electric appliances. If the plugging into the receptacle
is loose, do not use the plug any more.
2
Do not wash water-proof laundries like
the raincoat, bike covers etc. to avoid
abnormal vibrations in spinning.
Do not stretch hands into the working machine.
It is dangerous even if the rotation is slow.
Take special care of the children.
Do not decompose, repair or alter the machine
by yourself.
Do not put any hot or heavy items (such as the kettle
with hot water) on the washing machine
The appliance is not instruct for use of
young children of infirm persons without
supervision.Young children should be
supervised to ensure that they do not
play with the appliance.
The lint filter shall be kept in good condition, and
installed to proper position. If the lint filter is lost
or damaged, please contact the local after-sales
service department of our company.
Dismantle
The cover of lint filter
lint filter
Install
Dismantle
lint filter
The back cover of lint filter
Install
Do not wash laundries with volatile materials
(such as thinner, petrol etc.).
Benzene
Keep the machine away from direct sunlight and
heat source like the heater.
To prevent your laundries and washing machine from
damages, be sure to take out all of the foreign materials
from your pocket, such as coins, buttons, sandor hair
pins etc.
Before washing, please check if the water tap is open,
and if the water inlet pipe is connected properly.
It is suggested to use low-foaming washing powder.
3
Please install and adjust the machine according to the requirement of the manual.
It is very important to your security and correct operating the machine.
Install the inner cover components
1.Open the top lid of the washing machine.
2.Put the inner cover component on the outer tub cover, aiming
the inner cover shaft to the installation hole of the corresponding
outer tub cover shaft groove.
3.Firstly insert the inner cover shaft of I side into the correspon
-ding outer tub cover shaft groove, then push the another inner
cover shaft into the corresponding outer tub cover shaft groove.
Please install to designated position to guarantee there are no
dropping or abnormal sound in opening and closing of the inner
cover, and the operation shall be smooth. Do not dismount the
inner cover component after washing.
Install the bottom plate
Outer tub cover
shaft groove
Inner cover shaft
Outer tub cover
Inner cover
After opening the package, please lean
the washing machine gently down on
soft items (like towel cloth, blanket, etc.).
Install the bottom plate to the bottom
of the machine with eight screws by a
cross screwdriver, then lift the
machine up gently. See to the figure:
Bottom plate
Adjust the Installation position
The largest allowed slope of the shank base of the machine is 2 . The slanting or rough ground will result in
unstable running or stoppage of the machine. Please adjust it with following methods:
Confirm it's horizontal
Hang the plumb to confirm it's
horizontal
Adjust the adjustable foot
(1) To twist the adjustable foot at the right front of
the cabinet (front the sight of front), please first
lift up the side of the foot slightly, loosen the
adjustable nut, and twist the foot.
(2) Fasten the nut after adjustment.
Loosen
High
Low
4
Screw
Fasten
Back
Front
Soft items
adjustable nut
adjustable foot
Loading...
+ 13 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.